CH309012
Chandelier
TECHNICAL SUPPORT
1.833.MY ALORA(692.5672)
technicalsupport@aloralighting.co m
WARNINGS AND CAUTIONS
Important: ALWAYS be sure to
To avoid the risk of fire and/or shock fixture must be installed in compliance to national and local electrical and building codes.
If an existing fixture is being replaced take special notice of which wires were connected in the outlet box.
DO NOT SEPARATE ANY WIRES THAT MAY BE EXISITING IN THE JUNCTION BOX
DO NOT DAMAGE THE INSULATION OF JUNCTION BOX WIRES.
In Regular circumstances the BLACK wire will be “live”, WHITE will be “neutral” and GREEN or BARE COPPER will be “ground”. In older buildings it is always good practice to
reconfirm the polarity of the wiring.
NOTICE
• The important safeguards and instructions outlined in this sheet cannot cover
all possible conditions and situations that may occur. It must be understood
that caution and certain care factors must be followed. These instructions are
provided for your safety and we highly recommend that a licensed, trained
electrician install this unit.
• This fixture is designed to be mounted on a correctly installed standard round
or octagon box OR through a wiring box with a plaster frame. The box must be
securely mounted to the structure of the building. The crossbar and hardware
supplied should be used, directly mounting the fixture to the outlet box may
make it impossible to correctly align the fixture.
disconnect power before re-lamping or wiring the fixture. Read these instructions completely before starting installation.
1a.
1b.
1c.
1e.
1d.
2a.
2b.
ASSEMBLY INSTRUCTIONS
Step 1
Determine the desired length the fixture will hang by selecting from the
assorted rod sizes supplied (2c). Slide selected rods through the fixture wires
and thread the rod assembly to fixture body (3a). Remove the mounting
crossbar (1c) from within the canopy (2a) by loosening the mounting collar
nut (2b). Slide mounting collar nut (2b) followed by canopy (2a) through wire
and rods. Feed fixture wires through canopy pivot (1e) and mounting
crossbar (1c) and thread canopy pivot (1e) to fixture assembly.
Step 2
Attach mounting crossbar (1c) to junction box (1a), using two junction
box screws (1d) (not provided). Cut down the extra wire and connect fixture
wires to junction box wires using the marrettes provided (1b). (white to white
“N”, black to black “L”, green to green “G”). Slide canopy (2a) and mounting
collar nut (2b) towards ceiling and thread on the mounting collar nut (2b).
This will secure the canopy to mounting crossbar.
Step 3
Install recommended lamps (3c) (not provided) (referred on the socket label
for maximum wattage and type) to fixture sockets (3b). Secure the glass
shades (3d) to fixture sockets (3b) turning clockwise and restore power. *If
fixture has integrated LED (Lighting Emitting Diodes) lamp installation is not
required*
You are now ready to enjoy your fixture.
3d.
3c.
2c.
3a.
3b.
P.
1.833.MY AL ORA (692.5672)
CANADA : 102 ∙19028 27TH Ave. - Surrey, BC V3Z 5T1
USA : 3035 E. Lone Mountain Rd - Las Vegas, NV, 89081
www.alor alighting.com
Loading...