Allstar Performance ALL81330 User Manual

Box mount provides a quick release method for replacing
MSD6420, 6425, 6430 and other ignition boxes with 7-1/2" x 3-1/2"
center to center mounting dimensions.

CONTENTS:

A. Box Mount
B. Quick Turn Fastener (x4)
C. Steel Spring (x4)
D. 1/8" Aluminum Rivet

A

MSD Box Mount

INSTRUCTIONS

Figure 1

D

B

Step 1:

Determine placement of box mount - use Box Mount (A) as a
template to trace the four large holes onto body panel. Next,
carefully drill each traced hole to 7/16". Use of a stepped drill bit
is recommended. If a stepped drill bit is not available, start out
with a smaller size bit and work up to a 7/16".

Step 2:

Secure Steel Springs (C) to Box Mount (A) using Aluminum Rivets
(D). Figure 1.

Step 3:

Secure assembled Box Mount (A) to holes previously drilled in
body panel using four Quick Turn Fasteners (B). Figure 2 and 3.

Step 4:

The basic box mount assembly is now complete. Secure MSD
ignition box to four remaining holes of Box Mount (A). Note,
hardware for this step not included but is typically supplied with
the MSD ignition box. Final assembly should appear as shown in
Figure 4.

C

Figure 2

Figure 3

Body
Panel

Box
Mount

Body
Panel

Figure 4

Allstar Performance 8300 Lane Dr., Watervliet, MI 49098

Phone: [phone] Fax: [phone] www.allstarperformance.com

Form 1082 Page 1 of 1 Rev. 022211