All Power APW5022 User Manual

2000 PSI Pressure Washer

Table Of Contents

Topic Page

Imporant Safety Tips, Precautions, Warnings, and Usage Instructions

Assembly Instructions 6- 8

Operating Instructions 9- 12

Detergents 12-13

Clean-up and Storage 14-15

Cleaning Tips 16

Technical Date 17

Troubleshooting Tips 18

Exploded View 19

Part Listing 20 21

Limited Warranty 22 23

2- 5

2000 PSI Pressure Washer

GROUND FAULT CIRCUIT INTERRUPTER (GFCI)

This pressure washer is provided with a ground fault circuit interrupter (GFCI) built into the plug of the power supply cord. This device provides additional protection from the risk of electric shock. Should replacement of the plug or cord become necessary, use only identical replacement parts that include GFCI protection.

This unit is equipped with a Ground Fault Circuit Interrupter (GFCI). When connecting the GFCI to the receptacle, the indicator should appear red. If the indicator is not red, depress the RESET button on the GFCI until the indicator appears red. If the indicator does not appear red, please see Section titled “Troubleshooting” for more information.

IMPORTANT SAFETY TIPS

Never point the high-pressure nozzle at people or animals.

Never drink alcohol or use drugs while operating the pressure washer.

Never operate the pressure washer while standing in water.

Never touch the electrical plug with wet hands.

Never let electrical connections rest in water.

Never operate pressure washer without the water turned on.

Never use hot water with this pressure washer.

2000 PSI Pressure Washer

IMPORTANT SAFETY PRECAUTIONS

WARNING: When using this product, basic precautions should always be followed, including the following:

1. Read all instructions before using the product. Save all

safety instructions.

2. Do not operate the pressure washer when fatigued or under

the influence of alcohol or drugs.

3. Risk of injection or injury – do not direct the high pressure

water stream at any people or animals.

4. Do not allow children to operate the pressure washer at any

time.

5. To reduce the risk of injury, close supervision is necessary

when the pressure washer is used near children.

6. Know how to stop the unit and reduce pressure immediately.

Be completely familiar with the controls.

7. Stay alert – always be aware of where you are directing the

high pressure spray.

8. Keep cleaning area clear of all people.

9. Keep good footing and balance at all times – do not

over reach or stand on an unstable support.

10. The work area should have adequate drainage to reduce the

possibility of a fall due to slippery surfaces.

11. Follow the maintenance instructions specified in the manual.

12. To reduce the risk of electrocution, keep all connections dry

and off the ground. Do not touch plug with wet hands.

GENERAL SAFETY PRECAUTIONS

1. Intended for outdoor household use only.

2. High-pressure hose can develop leaks from wear, abuse,

kinking etc. Do not use a damaged hose.

3. Do not use the pressure washer in areas near combustible

materials, combustible fumes, or dust.

4. Some chemicals or detergents may be harmful if inhaled or

ingested causing severe injury. Use a respirator or mask whenever there is a chance that vapors may be inhaled.

2000 PSI Pressure Washer

Read all instructions included with the mask so you are certain the mask will provide the necessary protection against inhaling harmful vapors.

5. Before starting the pressure washer in cold weather, check all

of the parts of the equipment and be sure that ice has not formed. Do not store the unit anywhere that the temperature will fall below 0

6. DO NOT MAKE ANY MODIFICATIONS TO ANY OF THE

COMPONENTS! Units with broken or missing parts, or without the protective housing or covers should NEVER be operated

7. Keep the high-pressure hose connected to the pressure

washer and the spray gun while the system is pressurized. Disconnecting the hose while the unit is pressurized is dangerous, and may cause injury.

8. Do not leave the pressure washer unattended while the power

switch is ON.

9. Keep water spray away from electrical wiring or fatal electric

shock may result.

° C (32° F).

SERVICING OF A DOUBLE-INSULATED APPLIANCE

In a double-insulated product, two systems of insulation are provided instead of grounding. No means of grounding is provided on a double-insulated product, nor should a means for grounding be added to the product. Servicing a double-insulated product requires extreme care and knowledge of the system, and should be done only by qualified service personnel. Replacement parts for a double-insulated product must be identical to the parts they replace. A double-insulated product is marked with the words “DOUBLE INSULATION” or “DOUBLE INSULATED”. This symbol may also be marked on the product.

USE OF EXTENSION CORDS

Use of an extension cord with this product is NOT RECOMMENDED. If you must use an extension cord, use only extension cords that are intended for outdoor use. These cords are identified by a marking “ACCEPTABLE FOR USE WITH OUTDOOR APPLIANCES, STORE INDOORS WHILE NOT IN USE.” Use only extension cords having an

2000 PSI Pressure Washer

electrical rating not less than the rating of the product. Examine extension cord before use. Do not use damaged extension cords! Do not pull on cord to disconnect from receptacle, always disconnect by pulling on plug. Keep cord away from heat and sharp edges. Always disconnect the extension cord from the receptacle before disconnecting the product from the extension cord.

WARNING

– To reduce the risk of electrocution, keep all connections dry and off the ground. Do not touch the plug with wet hands.

PROPER USE OF THE PRESSURE WASHER

THIS UNIT IS INTENDED FOR USE WITH COLD WATER ONLY!

DO NOT USE HOT WATER IN THIS PRESSURE WASHER.

Operate the pressure washer at no more than the fluid pressure

rated for the pressure washer. Never run the pressure washer without a water supply. Running the unit without a water supply will cause irreparable damage to the unit.

2. Make sure that the water supply you use for the pressure

washer is not dirty, sandy, and does not hold any corrosive chemical products. Using a dirty water supply will compromise the long life of the pressure washer.

3. CAUTION - The pressure washer can be used for a variety of

applications including washing cars, boats, patios, decks, garages etc. where high pressure is necessary to remove dirt and debris. High-pressure water flow can damage the work surface if not used properly! See the section titled “Operating Instructions” for more details. Always test the spray in an open area first.

4. NEVER move the unit by pulling on the high pressure hose. Use

the handle provided on the top of the unit.

5. Always hold the high pressure gun and wand with two hands.

Keep one hand on the gun/trigger, while supporting the wand with the other hand (see diagram).

6. When dispensing detergent, the pressure washer applies

detergent to the cleaning area at low pressure only. Once the detergent has been applied, spray the detergent off of the work area by using the adjustable nozzle.

2000PSI Pressure Washer

ASSEMBLY INSTRUCTIONS

Unpacking The Carton

After opening the carton, please remove all parts and check them against the following list of components that are included:

A. High Pressure Washer B. Gun C. High Pressure Hose D. Adjustable Nozzle

H. Gun-Shelve

E. Two-way Connector F. Water Intake Filter (Pre-Installed) G. Detergent Bottle

To assemble the enclosed parts, please refer to the steps that follow:

2000PSI Pressure Washer

Step 1

Insert the adjustable spray nozzle into the gun. Push and turn the adjustable nozzle clockwise onto the gun until hand tight to lock it in place. When the pieces are joined properly, you cannot separate the two components by pulling straight out on the adjustable nozzle. All attachments must be inserted into the gun for proper use.

Step 2

Attach the L-shape coupler end of the extension hose(N) into the water outlet and the other end into the hose reel(H).

L-shape connector

+ 16 hidden pages