ALL-SWI8180P
Industrial PoE Switch
• Rugged Industrial 8 port Gigabit POE Switch
• with 8x10/100/1000 TX 30W PSE (802.3af / at POE+)
• 48 -56VDC redundant power input
• Operating temp: -40°C to +75°C
Introduction
This industrial 8 port high power POE switch is designed for 48-56VDC input sources, especially for IP
surveillance, traf c monitoring and for a broad range of applications. It is equipped with 8 port 30W
PSE. It can deliver total 200Watts of power to your PD devices. It can be used as a stand-alone device
for buses, trucks, and other vehicles for Surveillance purposes. It is being rigorously tested for your
Security, Transportation and Telco application.
Part.-No. 134042
Errors and technical changes that serve the interests of progress or development of the product are reserved.
www.allnet.de
Speci cation
IEEE 802.3 10Base-T Ethernet
IEEE 802.3u 100Base-TX Fast Ethernet
IEEE 802.3ab 1000Base-T Gigabit Ethernet
IEEE Standard
Switch Architecture Back-plane (Switching Fabric): 16Gbps
Data Processing Store and Forward
Flow Control: IEEE 802.3x Flow Control and Back Pressure
Jumbo Frame 9KB
MAC address Table Size 1K
Packet Buffer Size 1M
Network Connector :
Network Cable
Protocol CSMA/CD
LED
Housing Heavy Metal Housing
Reserve polarity protection Present
Overload current protection Present
Power Supply
Power Consumption 5.76W@48 VDC full load, Without POE
IEEE 802.3z 1000Base-X Gigabit Ethernet
IEEE802.3x Flow Control and Back Pressure,
IEEE802.3af for POE
IEEE802.3at for POE+
8xRJ-45 10/100/1000BaseT(X) auto negotiation,
8 Giga POE+ 802.3at/af PSE 30W per port
Auto MDI/MDI-X function, Full/Half duplex
UTP/STP Cat.5e or above Cable
EIA/TIA-568 10-ohm (100m)
PW1(Power 1) Green,
PW2(Power 2) Green,
SW(relay) Amber,
TX/RJ-45 port:
LNK (Link/Active) Green,
Amber: POE Detected
Redundant Dual DC 12V-56V without POE
POE input 48-56VDC
Part.-No. 134042
Errors and technical changes that serve the interests of progress or development of the product are reserved.
www.allnet.de
Speci cation
Relay outputs with current carrying capacity of 1 A @24VDC,
Alarm Relay Contact
POE power
Removable Terminal Block
Operating Temperature -40°~75°C fully tested.
Operating Humidity 5% to 95% (Non-condensing)
Storage Temperature -40°~85° C
MTBF (mean time between failure) 510,304 hrs ( MIL-HDBK-217F) at 25°C
Housing Rugged Metal ,IP30 Protection
Case Dimension (L x W x D) 142mmx36.2mmx105mm (LxWxD)
Relay in open circuit mode when 2 powers are connected. in short circuit mode when only
one power supply is connected
POE power per port 30watts. Maximum 36Watts
Maximum total power 200Watts, with 56VDC input, Supports IEEE802.3af/at
Provide 2 Redundant power, Alarm relay contact ,6 Pin
Wire range: 0.34mm^2 to 2.5mm^2
Solid wire (AWG):12-24/14-22
Stranded wire(AWG): 12-24/14-22
Torque:5lb-In/0.5Nm/0.56Nm
Wire Strip length: 7-8mm
Installation mounting DIN Rail mounting and Wall Mounting
EN55022/24 ITE equipment
EN55011 Industrial, Scienti c and Medical (ISM) equipment
EMC/EMS CE, FCC, VCCI
EMI
FCC Part 15 Subpart B Class A,
CE EN 55022 Class A
Part.-No. 134042
Errors and technical changes that serve the interests of progress or development of the product are reserved.
www.allnet.de
Housing Dimension
Part.-No. 134042
Errors and technical changes that serve the interests of progress or development of the product are reserved.
www.allnet.de
Loading...