Assembly Instructions
Caution: You must read this before you proceed
Please look in the Backrest Panel for hardware packs and legs.
Chair
Caution: This Chair is NOT a TOY.
Keep your child/children at bay during the assembly process.
Whenever moving/lifting the Chair and to prevent damage to the Chair, two
adults are required to execute these actions.
1 of 7
Part List
Label Qty
A 1
B 1
C 1
D 1
E 1
Picture Description
Seat Panel
Backrest Panel
Right Leg
Left Leg
Cross Bar - 1
F 1
G 1
H 1
I 1
Cross Bar - 2
Cross Bar - 3
Seat Cushion
Back Cushion
Hardware
No. Qty
①
②
Picture Description
Bolt (M6x20)
Bolt (M8x35)
5
5
③
④
2 of 7
Bolt (M8x40)
Allen Key M4
7
2
Assembly Preparation
Before Beginning Assembly:
Assembly Steps
Overview
Backrest Panel (B)
Coss Bar - 3 (G)
Coss Bar - 2 (F)
Left Panel (D)
This Chair has multiple parts and may require up to 30 minutes to assemble. To give you
an overview of the Chair parts, the above picture is to help you put the various parts into
perspective. Please read through the instructions below to familiarise yourself with the
parts and steps before assembly.
FRONT FACING
Back Cushion (I)
Seat Cushion(H)
Right Panel (C)
Seat Panel (A)
Cross Bar - 1 (E)
3 of 7
Step 1
Attach Right Leg (C) and Left Leg (D) into the mortises of Cross Bar 1,2,3 (E)(F)(G) using
Unpack and place all parts on a clean, non-marring surface.
Step 2
G
C
F
E
D
Place Right Leg (C),Left Leg (D) and Cross Bar 1,2,3 (E)(F)(G) on a clean, non-marring
surface.
Insert tenons on Right Leg (C) and Left Leg (D) into the mortises of Cross Bar 1,2,3
(E)(F)(G) as shown above.
④
③
③
Bolt(③) with Allen Key(④) as shown in picture above.
Do not fully tighten the Bolts and Screw.
4 of 7
Step 3
④
②
A
Insert Seat Panel (A) into assembled Bench I using Bolt (②) with Allen key (④) as
shown in picture above.
Step 4
B
①
④
Insert tenons on Backrest Panel (B) into the mortises of Right Leg (C) and Left Leg (D)
as shown above.
Attach Backrest Panel (B) into the mortises of Right Leg (C) and Left Leg (D) using
Bolt(①)
Do not fully tighten the Bolts and Screw.
with Allen Key(④) as shown in picture above.
5 of 7
Step 4
I
H
Place Seat Cushion(H) and Back Cushion(I) onto Seat Panel (A).
Then EXERT pressure, floorwards onto the Chair with both hands.
This pressure will help the Chair reach full alignment at all joints.
In a sequential manner, gradually tighten all Screws at all joints until evenly
secured. Inspect the Chair and make sure all parts are adequately connected.
Your Chair is ready for use.
This Chair can only be used on a flat, level surface.
6 of 7
7 of 7
Loading...