ASSEMBLY AND INSTALLATION
INSTRUCTIONS
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
WARNING:
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
Hardware Package (included):
POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
Outlet Box
House Grounding Wire
Wire Nut (F)
Mounting Strap (A)
Fixture Mounting
Screw (D)
Ball Nut (G)
Green Grounding
Screw (B)
Lock Nut (E)
Mounting Screw (C)
Wire Nut (F)
Installation Steps
Turn off the power at fuse or circuit box.
1. Thread fixture mounting screws through mounting
strap, and then secure them with two lock nuts. Adjust
the length of fixture mounting screws if necessary.
2. Attach mounting strap to outlet box using two mounting
screws.
3. Rod Connections:
a. Thread the fixture wire from the fixture through the
lower rod, and then secure the lower rod onto fixture
using the threaded pipe.
b. Thread the fixture wire through the middle rod, and
then secure the middle rod onto the lower rod using
the threaded pipe.
c. Thread the fixture wire through the upper rod, and
then secure the upper rod onto the middle rod using
the threaded pipe.
Note: Length adjustable from 30-1/2" to 75-1/2". Use fewer rods if shorter length is desired.
4. Thread the fixture wire through coupling kit, canopy, and then secure the rod assembly to the coupling kit.
Fixture
Fixture Mounting Screw (D)
Mounting Strap (A)
Lock Nut (E)
Mounting Screw (C)
Green Grounding Screw (B)
Canopy
Ball Nut (G)
Coupling Kit
Upper Rod
Threaded Pipe
Middle Rod
Threaded Pipe
Lower Rod
Threaded Pipe
Threaded Pipe
Socket
Vintage Bulb
(not included)
Long Rod
Max.60W
5. Screw 12 long rods to the other threaded pipes of fixture.
6. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed wattage.
7. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follows:
---Connect the smooth-coated wire (marked) from the fixture to the black wire from the power source.
---Connect the ribbed-coated wire (unmarked) from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting strap with the green grounding screw, and then connect it to
the house grounding wire with a wire nut.
Carefully put the wires back into the outlet box.
8. Attach the canopy to the mounting strap, and then secure it with two
ball nuts.
9. Angled mounting recommended for a vaulted or angled ceiling.
(See Fig. 1)
Fig. 1
Support Brace
Turn on the power at fuse or circuit box.
The following parts are available for re-order if damaged or missing.
Spare Parts List:
Mounting Strap (A)
Lock Nut (E)
Green Grounding
Screw (B)
Wire Nut (F)
Mounting Screw (C)
Ball Nut (G)
Fixture Mounting
Screw (D)
Outlet Box
Canopy
Coupling Kit
Assembly Kit
5451MM (1 SET)
5688MM (1 SET)
12”Rod
3068RD
3089RD
A
6”Rod
3069RD
3090RD
3”Rod
3070RD
3091RD
B
A: 27-1/2"
Long Rod 295mm
5451DD
3092RD
B: 30-1/2"~75-1/2"
Loading...