Allied Telesis 795 TSL, S795HSL, S795, 795HSL, 795 User Manual
Specifications and Main Features
- Type Your Model: 795, $795, 795HSL, S795HSL, 795 TSL, S795 TSL
- Minimum Height for Mounting:43.0 (Nominal) With Minimum Range 40.0" to 46.0"
- Specification of the Cylinder:
- Bucket cylinder; bore 3.00, rod 1.50 stroke 20.75
- Lifting Cylinder: Bore 3.00, Rod 1.75 Stroke 30.00
- TSL Bucket Cylinder: Bore 3.00, Rod 1.75 Stroke 22.00
- Maximum Height Come Boom 163 .(13.6`)
- Clearance with Bucket Dumped Come Boom Fully Extended 137"(11-4)`
- Level at Which Height is Reached 25 Inches
- Level Dumping Angle Depending On Boom Extended 32.0 Degrees
- TSL Outside Dumping Angle fixed Assuming Boom Fully Extended 60.0 Degrees
- TSL Outside Dumping Angle Fixed Assuming Boom Ground Level 90 Degrees
- Bucket Rollback Angle Ground Level 19 Degrees
- TSL Bucket Rollback Angle 37 Degrees
- Depth Of Digging Or Maximum Depth Of Foetus Is 4 0
- Overall Height In Carry Position Of 84 0 7 vertical feet
- Rollback Angle at Full Extension 111 Chain Link/lock Nut Angles/ Nut
- TSL Bucket Rollback Assumes Hands On Controls With Maximum Lift 52
- Calculated breakout force 5705 Pounds
- Calculated lifting capacity 3100 Pounds
- All pins measure 1 and a quarter inches in diameter
Frequently Asked Questions
Q: What’s the maximum lifting limit of the loader?
A: The maximum lifting limit is approximately 3100 pounds or 1406.2kg.
Q: What is the maximum dump angle when fully raised?
A: The maximum dump angle when fully raised is 32.0°, and for TSL models, it is 60.0°.
Q: Is it possible to operate the loader when not seated in the tractor?
A: It is not possible, the loader should never be worked on unless an operator is properly seated on the driver’s seat of the tractor.
Q: How frequently should the hydraulic system be inspected for oil level?
A: The oil level in the system should be checked a lot so that it is ensured that the system is not empty especially before the operating of the loader.
Q: How can I fix the loader if it doesn’t seem to lift properly?
A: Look whether the loader specifications are adhered to and there are no internal leaks in the loading system, valves and ports.
User Manual
Loading...