Allied Brass DOK10219 Installation & Assembly

Page 1
INSTALLATION INSTRUCTIONS
Step1: Drill Holes in Wall for screws or screw anchors and attached Mounting plate to Wall
Determine your desired location for installation and make a mark for the location of the mounting plate. Remove mounting plate from backplate by loosening set screw in backplate as pictured below. Place center hole of mounting plate over mark made above. Make 2 marks where mounting screws will be placed as shown below. Drill hole at each of the marks. (You may substitute other style mounting anchors or screws if desired). Place anchors into the holes made. Place mounting plate over holes and secure to mounting surface using screws as shown below.
BACKPLATE
DRILLED HOLES
SCREW
MOUNTING PLATE
MOUNTING PLATE
DRILLED HOLE
ANCHOR
SET SCREW
Step2: Attach Bracket to Mounting Plate
Place bracket on mounting plate and secure by tightening set screw as shown below.
MOUNTING PLATE
BACKPLATE
SET SCREW
No portion of this document or any artwork contained herein should reproduced in any way without the written consent of ALLIED BRASS INC.
Loading...