Alliance Laundry Systems GT050N, GU050L, GU050N, HA050L, HA050N Operation & Maintenance Manual

...

Drying Tumblers

NOTA: Para bajar una copia de estas instrucciones en español, visite www.comlaundry.com.

Operation/Maintenance

50 Pound Capacity 75 Pound Capacity

Refer to Page 3 for Model Identification

Keep These Instructions for Future Reference.

(If this machine changes ownership, this manual must accompany machine.)

www.comlaundry.com

Part No. M414904R8

August 2007

Installation must conform with local codes or in the absence of local codes with:

In the U.S.A.

, installation must conform to the latest edition of the American National Standard Z223.1/

NFPA 54 “National Fuel Gas Code” and Standard ANSI/NFPA 70 “National Electric Code.”

In Canada

, installation must comply with Standards CSA-B149.1 or Natural Gas and Propane Code CSA

C22.1, latest edition, Canadian Electric Code, Part I.

In Australia

, installation must comply with the Australian Gas Association Installation Code for Gas

Burning Appliances and Equipment.

WARNING

FOR Y OUR SAFETY, the information in this manual must be followed to minimize the risk of fire or explosion or to prevent property damage, personal injury or death.

W033

POUR VOTRE SÉCURITÉ, les informations de ce guide doivent être respectées afin de réduire les risques d’incendie, d’explosion ou d’éviter les dommages matériels, personnels ou blessures mortelles.

MISE EN GARDE

• Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

• WHAT TO DO IF YOU SMELL GAS: – Do not try to light any appliance. – Do not touch any electrical switch; do

not use any phone in your building.

– Clear the room, building or area of all

occupants.

– Immediately call your gas suppli er from

a neighbor’s phone. Follow the gas supplier’s instructions .

– If you cannot reach your gas supplier,

call the fire department.

• Installation and service must be performed by a qualified installer, service agency or the gas supplier.

W052

• Ne pas entreposer ou utiliser d’essence ou toutes autres vapeurs et liquides inflammables à proximité de cette machine ou de tout autre appareil.

• QUE FAIRE EN CAS D’ODEUR DE GAZ : – Ne pas mettre d’appareil en marche. – Ne pas toucher aux interrupteurs

électriques ; ne pas utiliser le téléphone des lieux.

– Évacuer la pièce, le bâtiment ou la zone

de tous les occupants.

– Appeler immédiatement le fournisseur

de gaz de la maison d’un voisin. Respecter les instructions communiquées par le fournisseur.

– Si vous ne pouvez pas joindre le

fournisseur de gaz, appeler le service

FOR YOUR SAFETY

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

W053

d’incendie.

• L’installation et l’entretien doivent être effectués par un installateur, service d’entretien qualifiés ou par le fourn isseur de gaz.

POUR VOTRE SÉCURITÉ

W033R3QU

W052R5QU

Ne pas entreposer ou utiliser d’essence ou toutes autres vapeurs et liquides inflammables à proximité de cette unité ou de tout autre appareil.

W053R2QU

IMPORTANT: Information must be obtained from a local gas supplier on instructions to be followed if the user smells gas. These instructions must be posted in a prominent location. Step-by-step instructions of the above safety information must be posted in a prominent location near the tumbler for customer use.

M414904

Table of

Contents

Introduction......................................................................................... 3

Model Identification ............................................................................. 3

Customer Service.................................................................................. 4

Wiring Diagram .................................................................................... 4

Serial Plate Location............................................................................. 4

Safety Information.............................................................................. 5

Explanation of Safety Messages........................................................... 5

Important Safety Instructions ............................................................... 6

Operating Instructions ....................................................................... 8

Emergency Stop Button on CE Models................................................ 8

Operating Instructions .......................................................................... 8

Control Instructions .............................................................................. 9

Electromechanical Coin Control...................................................... 9

Manual Timer Control ..................................................................... 10

Dual Digital Timer Control.............................................................. 11

Electronic OPL Control ................................................................... 13

Reversing Operation ........................................................................ 14

Reverse Control Switch ................................................................... 14

Single Drop Control......................................................................... 15

MDC Coin Control .......................................................................... 17

MDC Card Control .......................................................................... 18

NetMaster Coin Control................................................................... 19

NetMaster Card Control................................................................... 20

Ignition Control Operation ................................................................... 21

Maintenance ........................................................................................ 23

Daily ..................................................................................................... 23

Monthly................................................................................................. 24

Quarterly ............................................................................................... 24

Bi-Annually .......................................................................................... 24

Before You Call for Service ............................................................... 27

Customer Service.................................................................................. 27

means without the expressed written consent of the publisher.

M414904

Introduction

Model Identification

Information in this manual is applicable to these models.

Gas Steam/Thermal Oil Electric

SA050L SA050N ST050D ST050L ST050N SU050L SU050N UA050L UA050N UT050L UT050N UU050L UU050N YT050L YT050N

ST075D ST075L ST075N STF75L STF75N SU075L SU075N UA075L UA075N UT075L UT075N UTF75L UTF75N UU075L UU075N YT075L YT075N

50 Pound

75 Pound

AT050L AT050N GT050L GT050N GU050L GU050N HA050L HA050N HT050D HT050L HT050N HU050L HU050N NT050L NT050N

AT075L AT075N GT075L GT075N GU075L GU075N HA075L HA075N HT075D HT075L HT075N HU075L HU075N NT075L NT075N SA075L SA075N

AT050S GT050S GU050S HT050S HT050T HU050S HU050T ST050S ST050T SU050S SU050T UT050S UT050T UU050S UU050T YT050S YT050T

AT075S GT075S GU075S HT075S HT075T HU075S HU075T ST075S ST075T SU075S SU075T UT075S UT075T UU075S UU075T YT075S YT075T YU075S YU075T

YU050S YU050T

AT050E GT050E GU050E HT050E HU050E ST050E SU050E UT050E UU050E YT050E YU050E

AT075E GT075E GU075E HT075E HU075E ST075E SU075E UB075E UT075E UU075E YT075E YU075E

Includes models with control suffixes:

BC – basic electronic, coin MT – manual timer RQ – reversing dual digital timer

BL – basic electronic, central pay NC – NetMaster coin RT – reversing manual timer

BU – basic electronic, prep card - open NR – NetMaster card SD – single drop

BX – basic electronic, prep for coin NX – NetMaster, prep for coin SX – single drop, prep for coin

BY – basic electronic, prep for card NY – NetMaster, prep for card ZC – NetMaster network, coin

CD – rotary coin drop OM – OPL Micro ZR – NetMaster network, card

CX – prep for coin QT – dual digital timer ZX – NetMaster network, prep for coin

CY – prep for card RM – reversing OPL Micro ZY – NetMaster network, prep for card

M414904

Introduction

Customer Service

If literature or replacement parts are required, contact the source from which the machine was purchased or contact Alliance Laundry Systems at (920) 748-3950 for the name and address of the nearest authorized parts distributor.

For technical assistance, call (920) 748-3121.

Wiring Diagram

The wiring diagram is located in the junction or contactor box.

Models starting Serial No. 0309____ or later will have the wiring diagram part number in the lower portion of the electrical data on the serial plate.

Serial Plate Location

When calling or writing for information about your product, be sure to mention model and serial numbers. Model and serial numbers are found on serial plate on rear of machine, and inside door hinge. Refer to Figure 1.

OL CO WN O

5 1

0 1

LOW

0 1

TEMPERATU

HEAT

IGH

0 5

3 0 4

PUSH TO

RT TA S

TMB803N

1 Serial Plate

Figure 1

TMB803N

M414904

Safety Information

Explanation of Safety Messages

Precautionary statements (“DANGER,” “WARNING,” and “CAUTION”), followed by specific instructions, are found in this manual and on machine decals. These precautions are intended for the personal safety of the operator, user, servicer, and those maintaining the machine.

DANGER

Indicates an imminently hazardous situation that, if not avoided, will cause severe personal injury or death.

WARNING

Indicates a hazardous situation that, if not avoided, could cause severe personal injury or death.

CAUTION

Indicates a hazardous situation that, if not avoided, may cause minor or moderate personal injury or property damage.

Additional precautionary statements (“IMPORTANT” and “NOTE”) are followed by specific instructions.

IMPORTANT: The word “IMPORTANT” is used to inform the reader of specific procedures where minor machine damage will occur if the procedure is not followed.

IMPORTANT: Warranty is void unless tumbler is installed according to instructions in the Installation Manual. Compliance with minimum specifications and requirements detailed herein, and with applicable local gas fitting regulations, municipal building codes, water supply regulations, electrical wiring regulations, and any other relevant statutory regulations. Because of varied requirements, applicable local codes should be thoroughly understood and all pre-installation work arranged for accordingly.

WARNING

Failure to install, maintain, and/or operate this machine according to manufacturer’s instructions may result in conditions which can produce serious injury, death and/or property damage.

W051R1

NOTE: The WARNING and IMPORTANT instructions appearing in this manual are not meant to cover all possible conditions and situations that may occur. It must be understood that common sense, caution and carefulness are factors which CANNOT be built into this tumbler. These factors MUST BE supplied by the person(s) installing, maintaining or operating the tumbler.

Always contact your dealer, distributor, service agent or the manufacturer on any problems or conditions you do not understand.

NOTE: The word “NOTE” is used to communicate installation, operation, maintenance or servicing information that is important but not hazard related.

M414904

Safety Information

Important Safety Instructions

Save These Instructions

WARNING

Hazardous Voltage. Can cause shock, burn or cause death. Allow machine power to remain off for two minutes prio r to w orking in and around AC inverter drive.

W359

1. Read all instructions before using the tumbler.

2. Refer to the GROUNDING INSTRUCTIONS

for the proper grounding of the tumbler.

3. Do not dry articles that have been previously cleaned in, washed in, soaked in, or spotted with gasoline, dry cleaning solvents, other flammable or explosive substances as they give off vapors that could ignite or explode.

4. Do not allow children on or in the tumbler. This appliance is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure that they do not play with the appliance.

5. Before the tumbler is removed from service or discarded, remove the door to the drying compartment and the door to the lint compartment.

6. Do not reach into the tumbler if the cylinder is revolving.

7. Do not install or store the tumbler where it will be exposed to water and/or weather.

8. Do not tamper with the controls.

9. Do not repair or replace any part of the tumbler, or attempt any servicing unless specifically recommended in the user-maintenance instructions or in published user-repair instructions that you understand and have the skills to carry out.

10. Do not use fabric softeners or products to eliminate static unless recommended by the manufacturer of the fabric softener or product.

11. To reduce the risk of fire, DO NOT DRY plastics or articles containing foam rubber or similarly textured rubberlike materials.

14. The interior of the tumbler and the exhaust duct should be cleaned periodically by qualified service personnel.

15. If not installed, operated and maintained in accordance with the manufacturer’s instructions or if there is damage to or mishandling of this product’s components, use of this product could expose you to substances in the fuel or from fuel combustion which can cause death or serious illness and which are known to the State of California to cause cancer, birth defects or other reproductive harm.

16. Tumbler will not operate with the loading door open. DO NOT bypass the door safety switch to permit the tumbler to operate with the door open. The tumbler will stop tumbling when the door is opened. Do not use the tumbler if it does not stop tumbling when the door is opened or starts tumbling without pressing or turning the START mechanism. Remove the tumbler from use and call for service.

17. Tumbler will not operate with lint panel open. DO NOT bypass lint panel safety switch to permit the tumbler to operate with the lint panel open.

18. Do not put articles soiled with vegetable or cooking oil in the tumbler, as these oils may not be removed during washing. Due to the remaining oil, the fabric may catch on fire by itself.

19. To reduce the risk of fire, DO NOT put clothes which have traces of any flammable substances such as machine oil, flammable chemicals, thinner, etc. or anything containing wax or chemicals such as in mops and cleaning cloths, or anything dry-cleaned at home with dry-cleaning solvent in the tumbler.

20. Use the tumbler only for its intended purpose, drying fabrics.

21. ALWAYS disconnect and lockout the electrical power to the tumbler before servicing. Disconnect power by shutting off appropriate breaker or fuse.

22. Install this tumbler according to the INSTALLATION INSTRUCTIONS. All connections for electrical power, grounding, and gas supply must comply with local codes and be made by licensed personnel when required.

12. Always clean the lint filter daily.

13. Keep area around the exhaust opening and adjacent surrounding area free from the accumulation of lint, dust and dirt.

M414904

Safety Information

23. Remove laundry immediately after tumbler stops.

24. Always read and follow manufacturer’s instructions on packages of laundry and cleaning aids. Heed all warnings or precautions. To reduce the risk of poisoning or chemical burns, keep them out of reach of children at all times (preferably in a locked cabinet).

25. Do not tumble fiberglass curtains and draperies unless the label says it can be done. If they are dried, wipe out the cylinder with a damp cloth to remove particles of fiberglass.

26. Always follow the fabric care instructions supplied by the garment manufacturer.

27. Never operate the tumbler with any guards and/or panels removed.

28. DO NOT operate the tumbler if it is smoking, grinding, has missing or broken parts.

29. DO NOT bypass any safety devices.

30. Solvent vapors from dry-cleaning machines create acids when drawn through the heater of the drying unit. These acids are corrosive to the tumbler as well as to the laundry load being dried. Be sure make-up air is free of solvent vapors.

31. Failure to install, maintain, and/or operate this machine according to the manufacturer’s instructions may result in conditions which can produce bodily injury and/or property damage.

WARNING

T o reduce the risk of serious injury, install lockable door(s) to prevent public access to rear of tumblers.

W055

M414904

+ 20 hidden pages

Alliance Laundry Systems GT050N, GU050L, GU050N, HA050L, HA050N Operation & Maintenance Manual

Specifications and Main Features

Frequently Asked Questions

User Manual