Alliance CTGC6EDG44 Installation Manual

Gear Cabinet

GER1C

Starting Serial No. 1103000001

Refer to Page 3 for Model Identification

Installation/Operation

Keep These Instructions for Future Reference.

(If this machine changes ownership, this manual must accompany machine.)

www.comlaundry.com

Part No. FR004028R4EN

February 2012

FOR YOUR SAFETY, the information in this manual must be followed to minimize the risk of fire or explosion or to prevent property damage, personal injury or death.

W033

• Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

• WHAT TO DO IF YOU SMELL GAS: – Do not try to light any appliance. – Do not touch any electrical switch; do

not use any phone in your building.

– Clear the room, building or area of all

occupants.

– Immediately call your gas supplier

from a neighbor’s phone. Follow the gas supplier’s instructions.

– If you cannot reach your gas supplier,

call the fire department.

• Installation and service must be performed by a qualified installer, service agency or the gas supplier.

W052

WARNING

FOR YOUR SAFETY

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

W053

POUR VOTRE SÉCURITÉ, les informations de ce guide doivent être respectées afin de réduire les risques d’incendie, d’explosion ou d’éviter les dommages matériels, personnels ou blessures mortelles.

W033R3QU

AVERTISSEMENT

POUR VOTRE SÉCURITÉ

Ne pas entreposer ou utiliser d’essence ou toutes autres vapeurs et liquides inflammables à proximité de cette unité ou de tout autre appareil.

W053R2QU

• Ne pas entreposer ou utiliser d’essence ou toutes autres vapeurs et liquides inflammables à proximité de cette machine ou de tout autre appareil.

• QUE FAIRE EN CAS D’ODEUR DE GAZ : – Ne pas mettre d’appareil en marche. – Ne pas toucher aux interrupteurs

électriques ; ne pas utiliser le téléphone des lieux.

– Évacuer la pièce, le bâtiment ou la

zone de tous les occupants.

– Appeler immédiatement le fournisseur

de gaz de la maison d’un voisin. Respecter les instructions communiquées par le fournisseur.

– Si vous ne pouvez pas joindre le

fournisseur de gaz, appeler le service d’incendie.

• L’installation et l’entretien doivent être effectués par un installateur, service d’entretien qualifiés ou par le fournisseur de gaz.

W052R5QU

FR004028 (EN)

Table of

Contents

Introduction......................................................................................... 3

Model Identification ............................................................................. 3

Customer Service.................................................................................. 3

Serial Plate Location............................................................................. 3

Wiring Diagram .................................................................................... 3

Safety Information.............................................................................. 4

Important Safety Instructions ............................................................... 5

Installation........................................................................................... 7

Specifications and Dimensions............................................................. 7

Cabinet Dimensions and Drain Connection Locations.................... 8

Exhaust Outlet and Electrical Connection Locations ...................... 9

Pre-Installation Inspection .................................................................... 10

Location Requirements......................................................................... 10

Gear Cabinet Enclosure ........................................................................ 11

Position and Level the Gear Cabinet .................................................... 12

Gear Rack Option ................................................................................. 13

Hanger Placement................................................................................. 13

Boot Rack ............................................................................................. 13

Exhaust Requirements .......................................................................... 14

Layout .............................................................................................. 14

Make-Up Air.................................................................................... 14

Venting............................................................................................. 14

Electrical Requirements........................................................................ 15

Grounding Instructions .................................................................... 15

Operation............................................................................................. 17

DMP OPL Models ................................................................................ 17

General Operation............................................................................ 17

Description of the OPL Control Panel ............................................. 18

DMP OPL Features............................................................................... 19

Removing Gear Cabinet from Service.............................................. 20

Before You Call for Service ............................................................... 20

Customer Service.................................................................................. 20

means without the expressed written consent of the publisher.

FR004028 (EN)

Introduction

Model Identification

Information in this manual is applicable to these models.

CTGC6EDG44 CTGC6EDG45 CTGC6EDG64 CTGC6EDG65 CUGC6EDG75

ITGC6EDG44 ITGC6EDG45 ITGC6EDG64 ITGC6EDG65 IUGC6EDG75

UTGC6EDG44 UTGC6EDG45 UTGC6EDG64 UTGC6EDG65 UUGC6EDG75

Customer Service

If literature or replacement parts are required, contact the source from which the machine was purchased or contact Alliance Laundry Systems at (920) 748-3950 for the name and address of the nearest authorized parts distributor.

For technical assistance, call (920) 748-3121.

Serial Plate Location

When calling or writing for information about your product, be sure to mention model and serial numbers. Model and serial numbers are found on serial plate on the right side of machine.

Wiring Diagram

The wiring diagram is located in the junction or contactor box.

FR004028 (EN)

Safety Information

Indicates an imminently hazardous situation that, if not avoided, will cause severe personal injury or death.

DANGER

Indicates a hazardous situation that, if not avoided, could cause severe personal injury or death.

WARNING

Indicates a hazardous situation that, if not avoided, may cause minor or moderate personal injury or property damage.

CAUTION

Failure to install, maintain, and/or operate this machine according to manufacturer’s instructions may result in conditions which can produce serious injury, death and/or property damage.

W051R1

WARNING

Precautionary statements (“DANGER,” “WARNING,” and “CAUTION”) followed by specific instructions, are found in this manual and on machine decals. These precautions are intended for the personal safety of the operator, user, servicer, and those maintaining the machine.

NOTE: The WARNING and IMPORTANT instructions appearing in this manual are not meant to cover all possible conditions and situations that may occur. It must be understood that common sense, caution and carefulness are factors which CANNOT be built into this gear cabinet. These factors MUST BE supplied by the person(s) installing, maintaining or operating the gear cabinet.

Always contact your dealer, distributor, service agent or the manufacturer on any problems or conditions you do not understand.

Additional precautionary statements (“IMPORTANT” and “NOTE”) are followed by specific instructions.

IMPORTANT: The word “IMPORTANT” is used to inform the reader of specific procedures where minor machine damage will occur if the procedure is not followed.

NOTE: The word “NOTE” is used to communicate installation, operation, maintenance or servicing information that is important but not hazard related.

FR004028 (EN)

Save These Instructions

To reduce the risk of fire, electric shock, serious injury or death to persons when using your gear cabinet, follow these basic precautions.

W775

WARNING

Safety Information

Important Safety Instructions

1. Read all instructions before using the gear cabinet.

2. Refer to the Grounding Instructions for the proper grounding of the gear cabinet.

3. Do not dry articles that have been previously cleaned in, washed in, soaked in, or spotted with gasoline, dry cleaning solvents, or other flammable or explosive substances as they give off vapors that could ignite or explode.

4. Do not allow children on or in the gear cabinet. This appliance is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure that they do not play with the appliance.

5. Before the gear cabinet is removed from service or discarded, remove the doors to the drying compartment.

6. Do not install or store the gear cabinet where it will be exposed to water and/or weather.

7. Do not tamper with the controls.

9. Do not use fabric softeners or products to eliminate static unless recommended by the manufacturer of the fabric softener or product.

10. Keep area around the exhaust opening and adjacent surrounding area free from the accumulation of lint, dust, and dirt.

11. The interior of the gear cabinet and the exhaust duct should be cleaned periodically by qualified service personnel.

12. Do not put articles soiled with vegetable or cooking oil in the gear cabinet, as these oils may not be removed during washing. Due to the remaining oil, the fabric may catch on fire by itself.

13. To reduce the risk of fire, DO NOT put clothes which have traces of any flammable substances such as machine oil, flammable chemicals, thinner, etc. or anything containing wax or chemicals in the gear cabinet.

14. Use the gear cabinet only for its intended purpose, drying water-washed fabrics.

15. ALWAYS disconnect the electrical power to the gear cabinet before servicing. Disconnect power by shutting off appropriate breaker or fuse.

16. Install this gear cabinet according to these Installation Instructions. All connections for electrical power and grounding must comply with local codes and be made by licensed personnel when required.

8. Do not repair or replace any part of the gear cabinet, or attempt any servicing unless specifically recommended in the usermaintenance instructions or in published userrepair instructions that you understand and have the skills to carry out.

FR004028 (EN)

+ 15 hidden pages