Allen & Heath ZED6FX Datasheet
Allen & Heath Limited
Kernick Industrial Estate
Penryn, Cornwall,
TR10 9LU, UK
www.allen-heath.com
Overview
Technical Datasheet
• 2 x Mic/Line Inputs with GS Preamps.
• Global 48V Phantom power.
• 2 x Switchable Hi-Z Input.
• 2 x Stereo Line Inputs.
• Internal FX Processing on all channels.
• Headphone Output.
• Hi-Pass filter on microphone inputs.
• HF & LF EQ adjustable pots on all channels.
• PFL select to headphone output.
Zed 6FX Technical Datasheet 1 Allen & Heath Ltd
Dimensions
236.4mm/9.3"
249 .0mm /9.8"
HEIGHT: 88.9mm (3.5”)
WIDTH: 249mm (9.8”)
DEPTH: 236.4mm (9.3”)
89.6mm/3.5"
249 .0mm /9.8"
A&E Specifications
The mixer shall be a compact and portable analog mixer with
two mono and two stereo input channels mixing to a stereo
Main Mix output. The mixer shall weigh no more than 1.36kg
(3lbs).
Each mono input channel shall have an XLR Microphone
connector and Line level quarter-inch jack connector and
shall be equipped with High Pass Filter and 2-band equaliser
circuit
Stereo input channels shall use quarter-inch jack connectors,
and shall have a fixed 2-band EQ.
All XLR Microphone inputs shall have the ability to power
Condenser Microphones requiring 48 Volt Phantom Power.
This shall be switchable and have a red LED to indicate
activation.
There shall be two high-impedance jack inputs on mono
channels, which can handle a normal line level or a low level
input directly from a guitar pickup, allowing instruments such
as guitars to be plugged straight into the mixer without the
need for a DI box.
XLR Mic input characteristics shall conform to a Gain Min/Max
of 6dB to 60dB with a maximum Input Level of 13dBu.
Quarter-inch jack Line input characteristics shall conform to a
Gain Min/Max of -14dB to 40dB with a maximum Input Level
of 18dBu.
The mixer shall have on-board effects which can be
independently applied to each input channel. In addition
there shall be an effects out on a quarter-inch jack connector.
236 .4mm /9.3"
The mixer surface shall include independent rotary control for
each input channels gain, level and mix. Each channel should
have individual Pan control and a [PFL] switch to route to the
headphone output. An LED shall indicate when a [PFL]
channel is active.
The Headphone output should use a quarter-inch jack
connector with a rotary to control output level.
The L&R outputs shall have XLR connectors and will be
controlled via a mix output fader. Level indication shall be via
a stereo eight segment LED display.
It shall have a built in power supply accepting AC mains
voltages of 100~240V, 50/60 Hz, 12W max via an earthed 3pin IEC C6 male connector mounted on the rear chassis.
A switch shall be provided near the mains inlet to isolate the
mixer from the incoming mains supply.
Recommended operating temperature for the mixer shall be
5 to 35 degrees Celsius.
The unit shall be the Allen & Heath ZED6FX.
Zed 6FX Technical Datasheet 2 Allen & Heath Ltd
Loading...