Allen & Heath ZED6 Datasheet

Allen & Heath Limited
Kernick Industrial Estate
Penryn, Cornwall,
TR10 9LU, UK

www.allen-heath.com

Overview

Technical Datasheet

• 2 x Mic/Line Inputs with GS Preamps.

• Global 48V Phantom power.

• 2 x Switchable Hi-Z Inputs.

• 2 x Stereo Line Inputs.

• Headphone Output.

• Hi-Pass filter on microphone inputs.

• HF & LF EQ adjustable pots on all channels.

• PFL select to headphone output.

Zed 6 Technical Datasheet 1 Allen & Heath Ltd

Dimensions

24 9.0m m/9. 8"

HEIGHT: 88.9mm (3.5”)

WIDTH: 249mm (9.8”)

DEPTH: 236.4mm (9.3”)

236.4mm/9.3"

88.9mm/3.5"

A&E Specifications

The mixer shall be a compact and portable analog mixer with
two mono and two stereo input channels mixing to a stereo
Main Mix output. The mixer shall weigh no more than 1.27kg
(2.8lbs).

Each mono input channel shall have an XLR Microphone
connector and Line level quarter-inch jack connector and
shall be equipped with High Pass Filter and 2-band equaliser
circuit

Stereo input channels shall use quarter-inch jack connectors,
and shall have a fixed 2-band EQ.

All XLR Microphone inputs shall have the ability to power
Condenser Microphones requiring 48 Volt Phantom Power.
This shall be switchable and have a red LED to indicate
activation.

There shall be two high-impedance jack inputs on mono
channels, which can handle a normal line level or a low level
input directly from a guitar pickup, allowing instruments such
as guitars to be plugged straight into the mixer without the
need for a DI box.

XLR Mic input characteristics shall conform to a Gain Min/Max
of 6dB to 60dB with a maximum input level of 13dBu.

Quarter-inch jack Line input characteristics shall conform to a
Gain Min/Max of -14dB to 40dB with a maximum input level of
18dBu.

The mixer surface shall include independent rotary control for
each input channels gain, level and mix. Each channel should

23 6.4m m/9. 3"24 9mm /9.8 "

have individual Pan control and a [PFL] switch to route to the
headphone output. An LED shall indicate when a [PFL]
channel is active.

The Headphone output should use a quarter-inch jack
connector with a rotary to control output level.

The L&R outputs shall have XLR connectors and controlled
via a mix output fader. Level indication shall be via a stereo
eight segment LED display.

It shall have a built in power supply accepting AC mains
voltages of 100~240V, 50/60 Hz, 12W max via an earthed 3­pin IEC C6 male connector mounted on the rear chassis.

A switch shall be provided near the mains inlet to isolate the
mixer from the incoming mains supply.

Recommended operating temperature for the mixer shall be
5 to 35 degrees Celsius.

The unit shall be the Allen & Heath ZED6.

Zed 6 Technical Datasheet 2 Allen & Heath Ltd