Allen-Bradley 25-FAN2-70C Installation Manual

Page 1
Installation Instructions
IMPORTANT
Horizontal mounting: up to 70 o C (max)
Horizontal mounting and zero stacking:
up to 65
o
C (max)
Vertical mounting: 60...70
o
C (max)
Vertical mounting and zero stacking:
55...65
o
C (max)
Frame A...D 25-FAN1-70C
Frame E 25-FAN2-70C
L1 L2 L3
O
I
1
Wait three minutes after shutdown for capacitors to discharge to safe voltage levels.
3
Install the Control Module Fan
Note: Fan kit installs to the same location above the control module across all frame sizes except frame E.
For Frame A...D For Frame E
a
b
PowerFlex 520-Series Control Module Fan Kit Installation
Catalog Numbers: 25-FAN1-70C, 25-FAN2-70C
The PowerFlex 520-Series Control Module Fan Kit is required for the following installations:
Publication 520-IN004B-EN-P - September 2013
2
DC+ DC–
0V
0V
Page 2
PowerFlex 520-Series Control Module Fan Kit Installation
Dimensions
4
Frame E
All dimensions are in mm (in.)
Esc
Sel
b
32.0 (1.26)
e
d
c
a
Frame A...C
Wiring the Control Module Fan
Frame EFrame A...D
Frame D
Note: Remove the label to access the built-in 24V supply on drive frames D and E.
Wire Size Torque Voltage Amps
0.32 mm
2
(22 AWG) 0.29...0.39 Nm
(2.6...3.47 lb-in)
22.8...27.6V DC 0.10...0.15 A
Note: An external 24V DC power source is required when using the Control Module Fan Kit with drive frames A, B, and C. Frames D and E have a built-in 24V supply.
Frame a b c d e
A 72.0 (2.83) 57.5 (2.26) 56.0 (2.20) 140.0 (5.51) 152.0 (5.98)
B 87.0 (3.43) 72.5 (2.85) 56.0 (2.20) 168.0 (6.61) 180.0 (7.09)
C 109.0 (4.29) 90.5 (3.56) 56.0 (2.20) 207.0 (8.15) 220.0 (8.66)
D 130.0 (5.12) 116.0 (4.57) 56.0 (2.20) 247.0 (9.72) 260.0 (10.24)
E 185.0 (7.28) 160.0 (6.30) 196.0 (7.72) 280.0 (11.02) 300.0 (11.81)
Note: Frames D and E cannot be mounted on a DIN-rail.
a
b
a
b
U.S. Allen-Bradley Drives Technical Support - Tel: (1) 262.512.8176, Fax: (1) 262.512.2222, E-mail: support@drives.ra.rockwell.com Online:
http://www.ab.com/support/abdrives.
Allen-Bradley, Rockwell Software, Rockwell Automation, PowerFlex, and TechConnect are trademarks of Rockwell Automation, Inc.
Trademarks not belonging to Rockwell Automation are property of their respective companies.
c a
b
52.0 (2.05)
e
d
Publication 520-IN004B-EN-P - September 2013
Supersedes Publication 520-IN004A-EN-P - December 2012 Copyright © 2013 Rockwell Automation, Inc. All rights reserved.
Loading...