Allegri 11804010SE001, 11804010FR001 User Manual

MODEL 11804

ASSEMBLY AND DRESSING INSTRUCTIONS

Blending innovative design, cutting-edge technology and the grace and elegance of traditional crystal, ALLEGRI® proudly brings you a new approach
to lighting. ALLEGRI® fixtures are made from the finest raw materials and are brought to life through a combination of traditional manufacturing, such
as sand casting, hand-forging and technology driven techniques including laser cutting.

Enclosed are detailed instructions on how to properly install your fixture. Please read all instructions carefully. If you need further assistance, please
contact the dealer from which you purchased this product or call 866-520-2665 to speak with an ALLEGRI® customer service representative. We
hope you enjoy your fixture!

WWW.ALLEGRICRYSTAL.COM

866.820.2665

This product must be installed in accordance with the National Electric Code (NEC), and appropriate local electrical code(s), by a
person familiar with the construction and operation of the product and the hazard involved.*



For your safety and proper operation of fixture, read and understand all instructions completely before commencing installation.

 This fixture is suited for dry locations. Never install fixture on damp ceiling; room should be dry and well ventilated.
 Extreme care should be taken to avoid damage to the surface of lighting fixture and wires. Wearing gloves is recommended for installation.



Connect ribbed wire of lighting fixture to live wire, while smooth wire of lighting to neutral. Connect bare copper or silver color ground wire of

fixture to the double colored or green wire of outlet box.



Use UL LISTED wire nuts for the wiring connections in this fixture. Wrap wire nut connections with UL LISTED electrical tape.



Keep lighting away from acid, alkali and other corrosive chemical or gas; clean the fixture with a clean cloth only.



Fixture must be firmly secured when installing ceiling tube, chain pipe and other connecting parts.



Never cover the lighting fixture when power is connected.

 Disconnect the power before installing, cleaning and/or replacing light bulb.



Extreme care should be taken when installing and cleaning of Glass and/or Crystal Components.



This product is rated 110-130V/60HZ bulb 40W Maximum.



Save these instructions for future reference.

T

he electricity must be turned off at the main fuse box or circuit breaker before installing this fixture. Turning the power off usin g t he li gh t sw it ch may

not be sufficient to prevent electrical shock.

*ALLEGRI will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

WWW.ALLEGRICRYSTAL.COM

866.820.2665

Please note: two or more installers may be needed to perform this fixture
installation.

WARNING

Electrical Danger Turn Power Off

All electrical components must be
installed by a licensed electrician in
accordance with the National
Electric code and the appropriate
local electrical codes.

Outlet box (by others)

Anchor screws (Not

provided)

Fixture Cross bar

Fixture Mounting

Screw

R

M5

Metal Flush Plate with
GU10 halogen bulbs

Decorative nuts

INSTALL FLUSH PLATE AS FOLLOWS:
CAUTION: Make sure power is off at the main breaker prior to installation.

Make sure ceiling can support weight of 200lbs otherwise make ceiling reinforcements.

1. If the installation is made on a concrete ceiling. Place cross bar on position flat to ceiling and mark mounting
screw holes to be drilled for anchor screws.

2. If installation is made in drywall or wood make sure reinforcements are made to support fixture's weight.

3. Install cross bar to ceiling make sure fixture mounting screws on cross bar are pointing towards the floor. (use
leveler to make sure the fixture mounting screws will match holes in flush plate).

WWW.ALLEGRICRYSTAL.COM

866.820.2665