Allegri 031723010FR000 User Manual

esAs
mbly & Installati
ton Ins
ructions f
031723-010-FR000 6-Light Wall lamp
Customer Service :(702)361-4345,(800)525-2655,customer.service@kalco.com WARMING - TO REDUCE THE RISK OF FIRE OR INJURY:
2.Turn off the power to the fixture's circuit at the service panel. Use a coltage detector to verify that the power is off.
3.DO NOT install bulb which exxeeds the maximum wattge specified on the socket label.
Fixture Assembly
Step 1. Place mount mounting and wiring steps before crystal installation step
Step 2. Assemble crystal tray to the lamp body as shown,Align holes in crystal tray with holes in fixture and secure crystal tray to fixture using headless screw
Flat screw
r:o
Step 3. Fix part Crystal tray to part Lamp body by using Flat screw .
Step 4. Lnstall candelabra bulbs bulb,do not use
bulbs that exceeds 60W
Change Bulbs: 1-Remove top and bottom screws while holding the crystal shade 2-Release crystal shade from back plate 3-Change bulbs and place crystal shade back in place.
Back Plate
Fixture crystal Shade
60W BULBS
esAs
mbly & Installati
031723-010-FR000 6-Light Wall lamp
Customer Service :(702)361-4345,(800)525-2655,customer.service@kalco.com
Fixtur
e Assembly
ton Ins
ructions f
r:o
Step 5. Fasten 2 (state specification of screw ) into mounting plate so that they extend away from wall when mounting plate is installed
Step 6. Attach the mounting plate to outlet box with sorews
Step 7. Refer to wiring diagram. Splice the ribbed side of fixture cord to the white supply wire from outlet box with wire connector. Splice the smooth side of the fixture cord to black supply wire from outlet box with wire connector
Step 8. Carefully tuck in all wires Attach the backplate with the mounting screw on the crossbar.Secure fixture with shell hnobs.
Electrical box
Wall plugs Mounting block
FLAT SCREW
Tapping screw
L
8
" screw
32
N
G
LAMP BODY
SOC
Fixture black and white wires
Change to black and white
UND
GRO
ERWI
S
KET
ANDE
NC (I
T) SCEN
Black & white supply wires
RESSE WIHOU
Loading...