
esAs
mbly & Installati
ton Ins
ructions f
031322-010-FR001 2-Light Wall Sconce
Customer Service :(702)361-4345,(800)525-2655,customer.service@kalco.com
C20-15-11-00
WARNING - TO REDUCE THE RISK OF FIRE OR INJURY:
1.lf you are unfamiliar with electrical wiring, call a qualified electrician to install this unit .More than
one person may be necessary to install fixture ,make sure you have enough qualified help.
2.Turn off the power to the fixture's circuit at the service panel. Use a voltage detector to verify that
the power is off.
3.DO NOT install bulb which exceeds the maximum wattage specified on the socket label.
Fixtur e Assembly
Step 1. Place mount mounting and wiring steps before
marble installation step
loop
Step 2. Assemble crystal bowl to the lamp body
as shown,Align holes in crystal with holes in fixture
washer
r:o
Step 3.
Step 4.Screw part center pipe to part main fixture.
Connect part washer
by using loop.
Connect part washer、cone column、crystal
column by using cone nut.
Connect part candle piper、crystal dish by using
main body.
Screw bulb into lampholder.
Check the installation.
Install candelabra,do not use
bulbs that exceeds 40W
、slat、crystal column
crystal column
60W bulb
washer
slat
Candle pipe
crystal dish
crystal column
center pipe
main body
center pipe
crystal column
washer
crystal column
C20-15-11-00
cone nut
crystal ornamental

esAs
mbly & Installati
031322-010-FR001 2-Light Wall Sconce
Customer Service :(702)361-4345,(800)525-2655,customer.service@kalco.com
Fixtur
e Assembly
ton Ins
ructions f
r:o
Step 5. Fasten 2 (state specification of screw )
into mounting plate so that they extend
away from wall when mounting plate is
installed
Step 6. Attach the mounting plate to outlet box
with screws
Step 7. Refer to wiring diagram.
Splice the ribbed side of fixture cord
to the white supply wire from outlet box
with wire connector. Splice the smooth
side of the fixture cord to black supply
wire from outlet box with wire connector
Step 8. Carefully tuck in all wires Attach the
back plate with the mounting screw on
the crossbar.Secure fixture with shell
knobs.
SOC
KET
ELECTRICAL BOX
MOUNTING BLOCK
FLAT SCREW
L
N
LAMP BODY
G
ANDE
NC (I
T) SCEN
Black & white supply wires
RESSE WIHOU
Fixture black and white wires
Change to black and white
UND
GRO
ERWI
S