Nokia N95, Symbian 3rd Edition - How to configure GPS Receiver
Please note you will only need to setup GPS for the first time only.
CoPilot will remember the GPS settings on exit, so you will only need
to configure your GPS on the first use.
1. Start CoPilot Live 6
2. From the Welcome Screen, tap GPS. The GPS Receiver is
automatically selected as Integrated by default when you first install
CoPilot, so you just need to select Back below
3. On the Welcome screen, select Going To, and input an Address
4. Select Options, then Add Stop
5. Select Address, and input the Address details, and then click Done
6. On the screen below, select Drive and you should see the “Determining
Current Position” screen which will then convert to a Map screen, and if
you start driving then, CoPilot will navigate you
NB: The first time the GPS Receiver is used it may take approximately
5 minutes to acquire a fix (but may take as long as 15 mins). You
can minimize this time by remaining stationary and positioning the
GPS Receiver so that it has a clear view of the sky unobstructed
by tall buildings and trees. Every subsequent fix (providing the
onboard battery is fully charged and holds the data) should result
in a quick fix of under 1 min.
7. From the screen below, you can scroll to GPS status by selecting
Back, and then select Options below
8. Now select Back, and scroll to and select GPS
9. On the screen below which shows that your GPS Receiver is
Integrated, scroll to the right using the central soft key, and you
can see that the GPS signal is Found
10. If you move the soft key to the right once more, you will see a
screen which shows whether your GPS Receiver has acquired a
2-D or 3-D fix or No Fix. Currently, it is showing No Fix
Loading...