Alimed 830210 Users Manual

Wireless LCD Pager (LPG) Quick Start Instructions 830101 (V4)

LCD Caregiver Pager functions directly with Up to 200 wireless transmitting device with

LCD numerical display room number and device number. Each wireless transmitting

device can be programed to a 4 bit digital number including Room number and Location

number on pager. When a resident gets up, the sensor pads active the wireless

transmitter, transmitter will send a wireless signal to the pager, the corresponding Room

number and Location number will flash to alerts caregivers to know Room number and

Location number where wireless device trigger the alarm.

Optional Transmitting devices

- Wireless fully sealed Pad Alarm

- Wireless fully sealed Floor Alarm

- Wireless Nurse Call Transmitter

- Wireless Call Buttons

- Wireless Door/Window Exit Alarm

- Wireless PIR Alarm

- Wireless Deluxe Pad Alarm

- Wireless Deluxe Pad/Magnet Alarm

- Wireless Voice Pad Alarm

- Wireless Voice Pad/Magnet Alarm

- Wireless Basic Pad Alarm

- Wireless Basic Magnet Alarm

- Wireless Basic Pad/Magnet Alarm

- Wireless Door light Alarm

- Wireless Nurse Call Receiver

1. Open the battery door and Insert batteries as shown.

LPG

Close the battery door.

2. Program Components to Work with LPG

Before programming the LPG and components, be sure to read through directions for

all of the components you will be programming to work with LPG. Make sure you are

prepared to program all of the components before you begin.

The LPG automatically exits programming mode after 10 seconds of inactivity. If you

are not prepared with all of your components, you may be forced to start again at the

beginning.

Each LPG can be programed to work with Up to 200 wireless components.

LPG can display 4 bit digital number including room number and location number to

indicate which device triggered the alarm or call.

Each component can be programed to a 4 bit digital number including Room number

and Location number

P Image

- Enter programming mode

On the pager, press and hold both UP and DOWN arrows for 5 seconds

and

First bit of 4 bit digital number will also be blinking indicating that the pager is now in programming

mode.

It is for programing the Optional Transmitting devices to pager

- Setting Room number and Location number

that you are attempting to pair the transmitter with

until you see P Image is blinking

1. While the First bit of 4 bit digital number will also be blinking, press and release the UP or DOWN

Button on the front of pager until desired number is selected.

2. Press and release the  Button, next bit of 4 bit digital number will be blinking, press and release

the UP or DOWN Button on the front of pager until desired number is selected. You can continue to

set all bit of 4 bit digital number in this way.

- Programming the transmitter to setting Room number and Location number

1. Press the button on the transmitter, and then hold for 5 seconds until the alarm light on the

transmitter flashes orange. Then release the button.

The pager will beep to signal a successful connection. Then it will re-enter programming mode in

case you need to connect other.

2. Setting next Room number and Location number that you are attempting to pair next transmitter with

and Programming the transmitter in this way.

- Exit programming mode

The pager automatically exits programming mode after 10 seconds of inactivity.

If you do not need to connect more devices, press and hold both the UP and DOWN arrows on the

front of the pager to exit programming mode and

Enter Working mode automatically.

3. Set notification mode for LPG

LPG have three notification mode.