Alimed 830208 Users Manual

Wireless fully sealed Pad Alarm (Sensor Pad Transmitter) 830208

103 Bed1

103- Room number
Bed1- location it will be installed

Quick Start Instructions (V4)

This Sensor Pad Transmitter (SPT) is a miniaturization wireless fall monitor for connecting
to a Wireless bed/chair Sensor Pads installed in bed, chair, wheelchair to configure a quite
wireless fall alarm. It does not need an additional monitor. When a resident gets up, the
wireless signal send to the door light Alarm, nurse call receiver and pager to alert
caregiver.

1. Record information on label

Before using a SPT, write its information on its label with an indelible marker first
(refer to below example),

2. Wake up Sensor Pad Transmitter

SPT is in sleep mode during shipping and store period. For a brand new SPT (not
programming to any device before), you will need to wake up it before programming

it to any device.
Wake up SPT by pressing and holding the Button (more than 5 seconds) on the SPT
until you see light is lighting.

Button

Optional receiving devices and alarm notification

- Wireless Nurse Call Receiver - caregivers can be notified at the nurse call station.

- LCD Pager - For carried by caregivers, Alerts caregivers with Vibration anywhere in
facility, Display alarm room number

- LED Pager, For carried by caregivers, Alerts caregivers with Vibration anywhere in
facility, Display alarm device number

- Door Light - Bright blinking light that can be easily seen down the hall, alerts
caregivers that someone is getting up from a bed, a chair or approaching an exit or
need help

- Wireless Display Board –This device have a large displayer which work similar to LCD
pager that displays room number up to 200 components. Hanging in the hallway or
mount high on wall for visibility, display alarm room number, have audible alert and
remote reset.

- Wireless Central Monitor–This device have a large displayer which work similar to
LCD pager that displays room number up to 200 components. Mount on desk at nurse
station, display alarm room number, have audible alert and remote reset.

3. Programming Sensor Pad Transmitter to receiving device

a. Triggering receiving devices to programing mode.

You may need to Setting Room number/Location /Device number that you are
attempting to pair the transmitter with on receiving devices. (Please refer to Quick
Start Instructions of each Wireless component)

b. Triggering Transmitter to programing mode by pressing and holding the Button (more

than 2 seconds) until you see Alarm light is flashing, and then release the Button, you
see Alarm light is lighting for 2 seconds, and then The receiving devices will beep and
light is flashing to signal a successful connection.

c. Connecting Wireless bed/chair Sensor Pad to SPT until connecter locked.