Alexander Jubilee Silver Overdrive User Manual

Roaring like a British Lion from Wembley to

the Sunset Strip, the Jubilee is ready to melt
faces. Sure, it can do subtle but that’s no
fun. Crank it up and rock out.

The Jubilee Silver Overdrive is based on the classic Pharaoh Ampli-

ers pedal of the same name. These pedals were produced in a very

limited number and were all sold to our dealer in Japan. We’ve

kept the circuit the same, and managed to cram the whole pedal in

a much smaller enclosure. Add in our celebrated relay based soft-

touch switching and you get the new Jubilee Silver Overdrive.

Controls:

LOUDNESS

overdrive your tube amp.

DRIVE

- Adjusts the gain and distortion of the pedal.

TREBLE, MIDDLE, BASS

voiced like a British amplier.

Bypass Switching:

The Jubilee features true bypass switching using a latching relay and

a soft-touch bypass footswitch. The Jubilee will power on in either

bypass mode or effect mode (useful if you are using the pedal with a

remote bypass switching system.) Hold the footswitch at boot to tog-

gle between bypass and effect startup modes. The pedal remembers

your settings when the power is removed. The Jubilee is fully analog.

- Controls the output volume of the boost. Crank it to

- Passive three-band tone stack,

Power Supply:

The Jubilee requires a DC power supply with a

2.1mm pin, center negative. The Jubilee will
operate on power supply voltages up to 18V
and does not use a battery. The Jubilee should
work ne on a multi-pedal “daisy chain” con­nector, but if you encounter excessive noise or
hum try a separate power supply. The Jubilee
requires approx. 12mA.

GREAT TONES. DOING GOOD.

404 E. Main St, Garner, NC 27529 [phone] alexanderpedals.com