Alera Lighting PPLS - Arch Sensors User Manual
sections
R
A
U
L
T
S
C
E
E
N
T
I
S
H
O
C
R
R
S
A
Installed Architectural Sensors Technical Installation Data
Plank Plus liso
2"
2"
9⅞"
BottoM View
Solid Housing
single Mounting (typical)
Connection Section
Sensor
Location
D
A
4', 8', 12'
5/16"
End Cap OptionCross Section 2T8
Sensor
Location
Perforated Strip Housing
Sensor
Location
row Mounting
C
A
B
B
B
Sensor
Location
4', 8', 12'
data chart
Nominal
Length
4' 17 lbs . 17 lbs . 47¼" 48" 192 ⅝" 48 ⅝"
8' 28 lbs. 28 lbs. 95¼" 96" 384 ⅝" 96 ⅝"
12' 40 lbs. 40 lbs. 143¼" 144" 576 ⅝" 144 ⅝"
Note: Suspension data is computed using the standard aircraft cable assembly. The use of rigid stems will yield dierent data.
Please consult factory for stem data.
Limitations exist for rows containing Installed Architectural Sensors; contact factory for assistance.
Page 1/2 Rev. 08/28/12 Beams / PPLS ARCHITECTURAL SENSORS TID
© 2012 Ale ra Lighting, a division of Hubbell Lighting, Inc. Because of continuin g product improvement programs , Alera Lighting reserves the ri ght to change specifications
without notice. 701 Millennium B lvd. Greenville, SC 2 9607 / Tel 864.678.1000 / Website www.aleralighting.com
See technical downloads for appropriate sensor manufacturer detail.
Approx. Weight
1-lamp 2-lamp
A B C D
Suspension Instructions:
1. Set bottom nut to desired xture height.
2. Adjust upper nut for a minimum of ⅜"
between upper and lower nuts.
3. Slide cable hanger into hanger slot.
4. Secure and tighten upper nut.
R
A
U
L
T
S
C
E
E
N
T
I
S
H
O
C
R
R
S
A
Installed Architectural Sensors Technical Installation Data
Plank Plus liso
Connection Instructions:
1. Install rst xture of row with two hangers.
2. Slide inner die cast plates together.
3. Secure xture joints with two bolts and nuts and attach hanger
at opposite end.
4. Repeat steps 2 and 3 until row is complete.
5. At each end of the row, attach and align end cap with screws.
Center upper reector and clip directly onto lamps
Page 2/2 Rev. 08/28/12 Beams / PPLS ARCHITECTURAL SENSORS TID
© 2012 Ale ra Lighting, a division of Hubbell Lighting, Inc. Because of continuin g product improvement programs , Alera Lighting reserves the ri ght to change specifications
without notice. 701 Millennium B lvd. Greenville, SC 2 9607 / Tel 864.678.1000 / Website www.aleralighting.com
Loading...