CROSS SECTIONS
MM, MMA SURFACE MOUNT
Technical Installation Data
2½"2½"
3½"
3½"
MMAMM Intermediate Section Connection Section
BOTTOM VIEW
SINGLE MOUNTING (TYPICAL)
ROW MOUNTING
96" 96"
(Shown with Lens)
6³⁄₁₆"
Single
A
1.75" Hole
F
96"
End Section
90³⁄₁₆"
Note: All xtures have a 1.75" diameter hole and is for mounting direct to the ceiling surface.
FACTORY STANDARD (TYPICAL ROW WITHOUT ENDCAPS)
8' 8' 8' 4'
DATA CHART
Nominal Length Weight A F
4' 16 lbs . 48⅜" 192⅜"
8' 28 lbs. 96⅜" 384⅜"
12' 40 lbs. 144⅜" 576 ⅜"
Page 1/2 Rev. 01/02/14 RECESSED / MM, MMA SM TID
© 2014 Ale ra Lighting, a division of Hubbell Lighting, Inc. Specifications subject to change without notice.
701 Millennium Blvd. G reenville, SC 29607 / Tel 864.678.1000 / Websi te www.aleralighting.com
MM, MMA SURFACE MOUNT
Technical Installation Data
CONNECTION INSTRUCTIONS
Conn Brackets (4 Places)
#8 Nuts
(6 Places)
Housing B
#8 Screws (6 places)
Housing A
Aligner w/ Pem
Studs (2 places)
Light Seal (2 Places)
1. Attach connector brackets to reector on
each housing using the #8 screws. Ensure
the angles are in the same direction on each
housing. (4 total)
2. Insert Top Light Seal halfway into one of the
Housings.
3. Insert Aligner with Pem Studs into the "C"
channel slots on one of the housings (2
total)
4. Use the #8 nuts to secure the aligner to the
housing A. (2 total)
5. Attach each Light Seal to the Aligner using
the #8 nuts. Do not tighten the nut at this
point. (2 total)
6. Butt Housing B against Housing A while
engaging Top Light Seal and electrically
connecting in-row wiring.
7. Engage the connector brackets with the
screws provided. Tighten the screws until
the housings are pulled together.
8. Secure the Aligner in Housing B with #8
nuts provided and tighten.
9. Tighten the nuts on the side light shields.
Page 2/2 Rev. 01/02/14 RECESSED / MM, MMA SM TID
© 2014 Ale ra Lighting, a division of Hubbell Lighting, Inc. Specifications subject to change without notice.
701 Millennium Blvd. G reenville, SC 29607 / Tel 864.678.1000 / Websi te www.aleralighting.com