Alera Lighting CVSL, CVPL User Manual
Curvista
Technical Installation Data
sections
9½"
BottoM View
single Mounting
2½"
End Cap Options
2½"
5⁄16"
Connection SectionCross Section
D
A
Flat Bull Nose Sculpted
4'
5 1/16"
2½"
2½"
5 5⁄16"
Row Mounting
data chaRt
Note: Suspension data is computed using the standard aircraft cable assembly. The use of rigid stems will yield dierent data. Please consult
factory for stem data.
4', 8'
C
A B B B
4', 8'
Nominal
Length
4' 13.1 lbs. 14. 3 lbs. 14.7 lbs. 47 ¼" 48" 192 ⅝" 48 ⅝"
8' 25.1 lbs. 26.3 lbs. 26.7 lbs. 95 ¼" 96" 384 ⅝" 96 ⅝"
1-lamp 2-lamp 3-lamp
Approx. Weight
A B C D
Page 1/2 Rev. 01/17/12 curves / CVSL CVPL TID
© 2012 Ale ra Lighting, a division of Hubbell Lighting , Inc. Because of continuing p roduct improvement p rograms, Alera Lighting reser ves the right to change specifications
without notice. 701 Millennium B lvd. Greenville, SC 29607 / Tel 864.678.1000 / Tech Supp ort 864.678.1580 / Website www.aleralighting.com
Curvista
Technical Installation Data
Connection Instructions:
1. Install rst xture of row with two hangers.
2. Slide inner die cast plates together.
3. Secure xture joints with two bolts and nuts
and attach hanger at opposite end.
4. Repeat steps 2 and 3 until row is complete.
5. At each end of the row, attach and align end
cap with two screws.
Suspension Instructions:
1. Set bottom nut to desired xture height.
2. Adjust upper nut for a minimum of ⅜"
between upper and lower nuts.
3. Slide cable hanger into hanger slot.
4. Secure and tighten upper nut.
Cover Removal:
1. Rotate fasteners 90 degrees.
2. Lift and remove.
Page 2/2 Rev. 01/17/12 curves / CVSL CVPL TID
© 2012 Ale ra Lighting, a division of Hubbell Lighting , Inc. Because of continuing p roduct improvement p rograms, Alera Lighting reser ves the right to change specifications
without notice. 701 Millennium B lvd. Greenville, SC 29607 / Tel 864.678.1000 / Tech Supp ort 864.678.1580 / Website www.aleralighting.com
Loading...