Alera Lighting APCS SLS User Manual

sections

bottoM view

91⁄2"

Cross Section

sLs - A+CLAss

SLS, Solaris Direct/Indirect Technical Installation Data

23⁄4"

Connection Section

8'

single Mounting

D

A

4, 8, 12 ft.

Row Mounting

C

A

B B

4, 8, 12 ft.

data chaRt

Nominal Approx. Weight Lbs. AB C D

4' 12 471⁄2" 48" 1921⁄4" 481⁄4"

8' 25 951⁄2" 96" 3841⁄4" 961⁄4"

12' 37 1431⁄2" 144" 5761⁄4" 1441⁄4"

Length 3-lamp*

Note: Suspension data is computed using the standard aircraft cable assembly. The use of rigid stems will yield dierent data. Please consult factory for stem data.
*3-Lamp includes CLC cover.

A

B

C D

B

to install a/v downlight coveR:

» »

1. Install center lamp. 2. Place A/V cover directly over center lamp. 3. Install outer lamps.

Page 1 /4 Rev. 07/16/13 curves / SLS-APCS TID

© 2013 Ale ra Lighting, a division of Hubbell Lighting, Inc. B ecause of continuing product imp rovement programs, Al era Lighting reserves the right to change specific ations
without notice. 701 Millennium Blvd. Greenville, SC 296 07 / Tel [phone] / Website www.aleralighting.com

US Patent #8,436,542

fixtuRe connections

Nut

sLs - A+CLAss

SLS, Solaris Direct/Indirect Technical Installation Data

Screw

Diecast Coupler

Connection Instructions

1. Install rst xture of row with two hangers.

2. Place bolts through openings in internal end cap.

3. Slide diecast coupler over end of xture with bolts. Screw
bolts through threaded holes in coupler to retain coupler.

4. Slide other xture onto bolts and attach nuts.

5. Repeat steps 2, 3 and 4 until row is complete.

6. At the end of the row attach diecast end caps with
appropriate nuts.

suspension attachMent

Suspension Instructions

1. Set bottom nut to desired xture height.

2. Slide cable hanger into hanger slot.

3. Secure and tighten upper nut.

4. Push plunger down to adjust cable to proper
suspension. Cut excess cable.

5. For ne-tuning of xture balance, slide
knuckle across yoke. Twist cable gripper to
lock in place.

Cable
Gripper

Plunger

Yoke

Nut

Page 2 /4 Rev. 07/16/13 curves / SLS-APCS TID

© 2013 Ale ra Lighting, a division of Hubbell Lighting, Inc. B ecause of continuing product imp rovement programs, Al era Lighting reserves the right to change specific ations
without notice. 701 Millennium Blvd. Greenville, SC 296 07 / Tel [phone] / Website www.alerali g hting.com

US Patent #8,436,542