Alera Lighting APCS PLK User Manual
sections
Plank - a+ClaSS
Technical Installation Data
2"
2"
⁄"
9 ⅞"
BottoM View
Solid Housing
single Mounting (typical)
row Mounting
A
Connection Section
End CapCross Section 3T8
Perforated Strip Housing
D
A
4, 8, 12 ft.
C
B
B
B
4, 8, 12 ft.
data chart
Nominal
Length
4' 19 lbs. 47 ¼" 48" 192 ⅝" 48 ⅝"
8' 32 lbs. 95 ¼" 96" 384 ⅝" 96 ⅝"
12' 44 lbs. 143 ¼" 144" 576 ⅝" 144 ⅝"
Note: Suspension data is computed using the standard aircraft cable assembly. The use of rigid stems will yield dierent data. Please consult factory for stem data.
*3-Lamp includes CLC cover.
Approx. Weight
3-lamp*
A B C D
to install a/V downlight coVer:
» »
1. Install center lamp. 2. Place A/V cover directly over center lamp. 3. Install outer lamps.
Page 1 /4 Rev. 07/16/13 Beams / PLK-APCS TID
© 2013 Ale ra Lighting, a division of Hubbell Lighting, Inc. B ecause of continuing product imp rovement programs, Al era Lighting reserves the right to change specific ations
without notice. 701 Millennium Blvd. Greenville, SC 296 07 / Tel 864.678.1000 / Website www.aleralighting.com
US Patent #8,436,542
Suspension Instructions:
1. Set bottom nut to desired xture height.
2. Adjust upper nut for a minimum of ⅜"
between upper and lower nuts.
3. Slide cable hanger into hanger slot.
4. Secure and tighten upper nut.
Plank - a+ClaSS
Technical Installation Data
Connection Instructions:
1. Install rst xture of row with two hangers.
2. Slide inner die cast plates together.
3. Secure xture joints with two bolts and nuts and attach hanger
at opposite end.
4. Repeat steps 2 and 3 until row is complete.
5. At each end of the row, attach and align end cap with screws.
Page 2 /4 Rev. 07/16/13 Beams / PLK-APCS TID
© 2013 Ale ra Lighting, a division of Hubbell Lighting, Inc. B ecause of continuing product imp rovement programs, Al era Lighting reserves the right to change specific ations
without notice. 701 Millennium Blvd. Greenville, SC 296 07 / Tel 864.678.1000 / Website www.aleralighting.com
US Patent #8,436,542
Loading...