ALEKO
www.AlekoProducts.com
TODDLER SWING - BSW02
STEP 1 Seat Assembly
9
9
Step A:
Carefully fold over the seat
armrest followed by the base
as shown in the diagram.
Step B:
Position the back so that it is at a 90
degree angle to the base, pushing down on
it until it clicks into place.
You can
You can
check the
check the
seat is
seat is
aligned as
aligned as
you will be
you will be
able to see
able to see
through the
through the
holes on the
holes on the
sides of the
sides of the
seat.
seat.
6
Step C:
Once the seat has been aligned, push
the two orange pins firmly into the
sides of the seat until they fully fit into
the backrest. Please note that if the pins
are forced into the seat when it has not
been aligned, it will cause the pins to
break.
STEP 3
Frame Assembly
F1
M6 BOLT 25mm x 2
Locknut
F3
42 mm
bolt
1
3
STEP 4 Seat Belt Assembly
To Close Harness
Push
Push
F3
M6 BOLT 42mm x 2
1
2
Take Care When Seating Your Child!
The child must be secured to the seat
immediately to avoid any injury.
3
F4
25 mm
F1
bolt
4
5
Fixing Knob
M6 BOLT 47mm x 2
1
2
F4
47 mm
bolt
STEP 2
Frame & Swing Assembly
F2
HEAD BOLT 35mm x 4
1
1
F2
To fasten push
both left and right
hand side clips
into the harness
until they click
into place.
To Open Harness
7
7
Pull
Push
10
To Attach Rope
Clamps:
Undo the screws on
each hinge and attach
both of the rope
clamps. Tighten the
screws to finish.
Loading...