Aleco Clear-Flex II with Universal Mounting System User Manual

Under Header (Lintel) Position

Wall (Header) Position

Wall

Fastener Supplied
by Others

Bracket Hardware

Threaded Stud

Nut

Face Plate

Strips

Front View Strip Spacing

Diagram 1

Wall

Fastener Supplied by
Others

Bracket Hardware

Threaded Stud

Nut

Face Plate

Strips

Diagram 2

Diagram 3

Strip Door Installation Instructions

TOOLS NEEDED

• Pen or Pencil to Mark Drill Holes

• Drill

• 7/16” Diameter Fasteners

• Step Stool or Ladder

• Utility Knife to Cut Strips

IMPORTANT

Prior to installation, unroll all door strips and place them on
a clean, flat surface in a warm atmosphere for a minimum of
twenty-four (24) hours. This will allow the strips to return to
their original form.

1. Mount the hardware bracket in either the
under header or wall position shown in
Diagrams 1 and 2 using appropriate
fasteners supplied by others (recommended
7/16” diameter).

2. Press the door strips onto the threaded
studs of the hardware bracket making
certain that the concave sides are facing
each other (Diagram 4). Attach strip
numbers 1 and 3 (see Diagram 3) with
concave side toward you, leaving desired
spacing between strips as indicated by the
diagram on reverse side of this sheet.

Diagram 4

3. Attach strip number 2 with concave side
away from you over strip numbers 1 and 3
(Diagram 3). Slide the supplied face plates
onto the threaded studs. Then, screw the
supplied nuts onto the threaded studs.

4. Attach all of the remaining door strips in the
same manner as in Steps 2 and 3 making
certain that the concave sides face each
other (Diagram 4).

5. After all door strips have been attached, the

strips should be trimmed to leave ¼” of
clearance from the floor surface. Your PVC
door strips may be trimmed by using a
common utility knife to score and then be

torn by hand. The door strips need to

hang for 24 to 48 hours before final trim
to allow for proper alignment.

FOR ANY QUESTIONS OR COMMENTS, PLEASE CONTACT AN ALECO REPRESENTATIVE

2720 E. Avalon Ave. Muscle Shoals, AL 35661 ● Phone [phone] or toll free 1-800-633-3120

Fax: [phone] ● email: [e-mail] ● web: www.aleco.com

P/N: 994177

0607

(2”)

6” WIDE
MATERIAL

8” WIDE
MATERIAL

12” WIDE
MATERIAL

16” WIDE
MATERIAL

STRIP PLACEMENT GUIDE

PARTIAL OVERLAP FULL OVERLAP

PARTIAL OVERLAP 66%

PARTIAL OVERLAP 50%

PARTIAL OVERLAP 66% (4”)

”

FULL OVERLAP 100%

FULL OVERLAP 100%

PARTIAL OVERLAP 75% (6”)
PARTIAL OVERLAP 50% (4”)
PARTIAL OVERLAP 25%

FULL OVERLAP 100%

Specially formulated Vinyl Strip Cleaner available exclusively through your local Aleco distributor.