Aleco Clear-Flex II with MaxBullet Mounting System User Manual

Wall

Lag Screw

MaxBullet
Bracket

Bullet

Seal opening here

Strips

® Hardware

Front View w/ Strip Spacing

Diagram 1

Side View

Diagram 2

iagram 3

D

Clear-Flex II® Strip Door Installation
Instructions (Food Service Model)

Using the Maximus System Hardware

TOOLS NEEDED

• Pen or Pencil to Mark Drill Holes *

• Drill

• 5/16 Di ameter Fasteners

• Step Stool or Ladder

• Utility Knife to Cut Strips

IMPORTANT

Prior to installation, unroll all door strips and place them on
a clean, flat surface in a warm atmosphere for a minimum of
twenty-four (24) hours. This will allow the strips to return to
their original form.

1. Mount the MaxBullet® hardware bracket
using lag screws provided on the inside wall
of walk-in, centered appropriately above
conventional door opening.

2. Seal opening at ends of MaxBullet®
hardware bracket with NSF-approved
silicone sealant (Diagram 1).

3. Press the door strips onto the “bullets” of the
hardware bracket making certain that the
concave sides are facing each other
(Diagram 3). Attach strip numbers 1 and 3
(see Diagram 2) with concave side toward
you, leaving desired spacing between strips
as indicated by the diagram on reverse side
of this sheet. Then attach strip number 2
with concave side away from you. Proceed
with strip number 5 toward you, again
leaving the appropriate spacing as per
diagram on reverse side of this sheet.
Proceed until all strips are in place.

4. Once all of the door strips have been
attached, the strips can be trimmed to leave
¼” of clearance from the floor surface. Your
PVC door strips may be trimmed by using a
common utility knife to score and then be
torn by hand. The door strips need to

hang for 24 to 48 hours before final trim
to allow for proper alignment.

* NSF certification applies when hardware is installed with approved low-temp PVC strip material.

FOR ANY QUESTIONS OR COMMENTS, PLEASE CONTACT AN ALECO REPRESENTATIVE

2720 E. Avalon Ave. Muscle Shoals, AL 35661  Phone [phone] or toll free 1-800-633-3120

Fax: [phone]  email: [e-mail]

 web: www.aleco.com

P/N 477251
(Rev 0511)

(2”)

6” WIDE
MATERIAL

8” WIDE
MATERIAL

12” WIDE
MATERIAL

16” WIDE
MATERIAL

STRIP PLACEMENT GUIDE

PARTIAL OVERLAP FULL OVERLAP

PARTIAL OVERLAP 66%

PARTIAL OVERLAP 50%

PARTIAL OVERLAP 66% (4”)

”

FULL OVERLAP 100%

FULL OVERLAP 100%

PARTIAL OVERLAP 75% (6”)
PARTIAL OVERLAP 50% (4”)
PARTIAL OVERLAP 25%

FULL OVERLAP 100%

Specially formulated Vinyl Strip Cleaner available exclusively through your local Aleco distributor.