Caution :You must read this before you proceed
CHAIR
Label Picture Description QTY
A Chair Base 1
B Chair Backrest 1
C Front Leg 2
D Hind Leg 2
Label Picture Description QTY
①
Bolt（M6*50mm)
1
1 of 5
②
Plastic Washer 7
③
Before
Beginning
Assembly:
Flat Washer 2
OVERVIEW
Chair Backrest(B)
Chair Base(A )
Hind Leg (D)
Front Leg(C)
FRONTFACING
This CHAIR has multiple parts and may require up to 30 minutes to assemble. To
give you an overview of the CHAIR parts, the above picture is to help you put the
various CHAIR parts into perspective.
Please read through the instructions to familiarise yourself with the parts and
steps before assembly.
2 of 5
Step 1
Chair Base(A )
Place the Chair Base(A) on a clean,non-marring surface.
Take out the 4 wooden legs and Hardware from inner box,as above picture shown
on.
Step 2
Chair Backrest(B)
Chair Base(A )
Install the Chair Backrest(B) to the Chair Base(A),push the Chair Backrest(B)
downwards until the Chair Backrest(B) is fully slotted and locked into position.
Step 3
①
Chair Base(A)
3 of 5
Attach the Chair Backrest(B) to the Chair Base(A) using Bolt(①) by hand as
shown above.
Step 4
Hind Leg (D)
D
②
Front Leg(C)
C
③
Chair Base(A)
②
Position the Chair Base(A) as shown above.
Install the Front Leg(C) into the bottom of the Chair Base(A) by placing one Plastic
Washer(②) onto the threaded stem,then tighten by turning the leg clockwise until
the leg is completely secure.
Install the Hind Leg(D) into the bottom of the Chair Base(A) by placing Plastic
Washer(②) and Flat Washer(③) onto the threaded stem,tighten by turning the leg
clockwise until the leg is completely secure.
Note: The use of Plastic Washer(②) are OPTIONAL and are especially
useful to help alleviate slight wobbleness. Some Legs may need more
than one Plastic Washer(②) whilst some Legs may not need any.
Step 5
Your Chair is ready for use.
Caution :This Chair can only be used on a flat, level surface.
4 of 5
5 of 5
Loading...