Page 1
INSTALLATION INSTRUCTIONS
PREPARING FOR INSTALLATION (Fig. 1)
1. Shut off power at the circuit breaker and remove the old
fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts in a clear area. Take care not to misplace any
small parts necessary for installation.
3. Thread the two studs (E) into the pre-drilled holes in the
circular strap (B) spaced the same distance apart as the
holes in the fixture back plate. The length of studs (E)
into circular strap (B) may be adjusted if necessary.
4. Attach circular strap (B) using outlet box screws (C) to
the outlet box (A) (Fig 1).
CONNECTING THE WIRES (Fig. 2)
5. Connect the electrical wires as shown in Fig.2. making
sure that all wire connectors are secured. If your outlet
box has a ground wire (green or bare copper), connect
the fixture’s ground wire to it. Otherwise, connect the
fixture’s ground wire directly to the long strap using the
green screw (H) provided.
COMPLETING THE INSTALLATION (Fig. 1)
6. To prevent moisture from entering the outlet box (A)
and causing a short, use clear silicone sealant to outline
the outside of fixture back plate where it meets the wall
leaving a space at bottom to allow moisture a means to
escape.
7. Align the fixture back plate onto studs (E) and secure
with cap nuts (F). (Fig 1)
8. At this point, unscrew the bottom finial (N) to remove
rubber washer (M), bottom cover (K) and glass shade
(H).
9. Install the light bulbs in accordance with the fixture
specification--DO NOT EXCEED THE MAXIMUM
WATTAGE RATING! (NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!)
10. Replace glass (H) followed by bottom cover (K) and
rubber washer (M) and secure with finial (N).
Your installation is now complete. Return power to the
outlet box and test the fixture.
BARE COPPER(GROUND)
Fig.2
FIXTURE
WIRES
WHITE
BLACK
(HOT)
WIRES
HOUSE
GREEN OR
WHITE
(NEUTRAL)
WIRES
HOUSE
(GROUND)
COPPER
BARE
FIXTURE
WIRES
BLACK
WIRES
FIXTURE
GREEN OR
HOUSE
WIRES
“CAUTION-RISK OF FIRE CONSULT A
QUALIFIED ELECTRICIAN TO ENSURE
CORRECT BRANCH CIRCUIT
CONDUCTOR”
ATTENTION – RISQUE D’INCENDIE, CONSULTER
UN ÉLECTRICIEN QUALIFIÉ POUR VOUS
ASSURER QUE LES CONDUCTEURS DE LA
DÉRIVATION SONT ADÉQUATS.
Fig. 1
READ AND SAVE THESE INSTRUCTIONS
WARNING ! SHUT P O WER O F F AT F U SE OR C I RCUI T BREAK E R.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Loading...