Page 1
ASSEMBLY INSTRUCTIONS
Description
Dimension
Cube Size : 41.9”x 18.6”x 10.6” NW: 35.2 LBS
GW: 41.8 LBS
DINING CHAIR WITH SLATTED BACK
- 1 -
: DINING CHAIR WITH SLATTED BACK
:18"1/2x21"1/2x39"1/2
Page 2
BEFORE ASSEMBLY
Thank you for purchasing our product. This product has been designed for easy assembly and long lasting use. Please take
the time to read and follow the assembly instructions carefully
Be sure to check all packing material carefully for small parts which may have come loose inside the carton during shipment. Please separate, identify, and
count all parts and metal hardware. Compare with part list to be sure all parts are present.
If hardware is missing or you have difficulty assembling this product, please call for us.
IMPORTANT NOTE:
- Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
- Remove all wrapping material, including staples & packing straps before you start to assemble.
- DO NOT tighten all screws and bolts until completely assembled.
- Keep all hardware parts out of reach of children.
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have the following parts:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
A
Chair back
1 B
Seat Frame
1
C
Front Leg
2
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED
Hardware bag
location
- 2 -
DINING CHAIR WITH SLATTED BACK
Page 3
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have all of the following hardware:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
1
Long bolt
(M6x80mm)
4 2
Medium bolt
(M6x60mm)
4
3
Short bolt
(M6x40mm)
2 4
Lock Washer
(∅6.5x9)
10
5
Flat Washer
(∅6.5x19)
10 6
Allen Key
(4mm)
1
STEP 1
Attach frame (B) to the back (A) by using bolts (3) and (1) and washers (4) and (5). Tighten with Allen Key (6).
Note: DO NOT fully tighten any of the bolt, until all chair parts are put together.
X2
DINING CHAIR WITH SLATTED BACK
- 3 -
Page 4
Attach front legs (C) to the seat frame. Use bolts (2), washers (4) and (5).Tighten with Allen Key (6).
.
Put the chair on a flat level surface to make sure the chair is level and then tighten fully the all bolts.
STEP 2
STEP 3
Check to make sure two
edges are flush or aligned.
Otherwise, the chair will be wobbly.
DINING CHAIR WITH SLATTED BACK
- 4 -
Loading...