Page 1
PIECE QUANTITY
A 1X
B1XC1XD1XE1XH1 8X
Weight Capacity: 275 lbs
H2 8X
WARNING: DO NOT STAND ON CHAIR
H3 8X
WARNING: DO NOT OVER TORQUE BOLTS/SCREWS
H4 1X
Allen bolt
Spring washer
THE DESIGN OF THE CHAIR IN THE DRAWINGS MAY VARY
FROM YOUR ACTUAL CHAIR, BUT ASSEMBLY IS THE SAME
ON ALL MODELS.
Back leg-1
Back leg-2
DESCRIPTION
PICTURE
SEAT
Front leg-1
Flat washer
Allen key
The legs and hardware are located underneath the chair in the
zipper compartment.
Front leg-2
CARE AND MAINTENANCE
Spot clean using a mild water-free solvent. Only a professional cleaner should
undertake a complete overall cleaning.
The use of steam or water-based cleaners may cause excessive shrinking or staining.
NOTICE
* Please make sure that you have all parts indicated before you begin assembly of this
item
* This item should be assembled on a soft surface to prevent scratching the finish
during assembly
* This item may require periodic tightening
Part List and Hardware List
ASSEMBLY INSTRUCTIONS APPLICABLE FOR ALL
OUR DINING CHAIRS.
Page 2
PREPARATION
The legs and hardware are located underneath the chair
in the zipper compartment.
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list.
If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 10 minutes.
Tools Required for Assembly (included): Allen Key
STEP1 OPEN THE ZIPPER ON THE UNDERSIDE OF THE SEAT AND
TAKE OUT LEGS AND HARDWARE
STEP2 PUT THE WASHERS ON THE BOLT IN THE ORDER SHOWN
IN THE PICTURE
ATTENTION
CORRECT INCORRECT
STEP3 INSERT THE FRONT LEGS AND SCREW IN THE BOLTS BUT
DON'T TIGHTEN COMPLETELY
STEP4 INSERT THE BACK LEGS AND SCREW IN THE BOLTS BUT
DON'T TIGHTEN COMPLETELY
STEP5 PUT THE CHAIR UPRIGHT AND MAKE SURE ALL LEGS ARE
LEVEL, THEN FIRMLY TIGHTEN BOLTS WITH ALLEN KEY WHILE
THE CHAIR IS UPRIGHT AS PICTURED ABOVE
STEP6 CLOSE THE ZIPPER ON THE UNDERSIDE OF THE SEAT,
THIS ITEM MAY REQUIRE PERIODIC TIGHTENING
H1
H2
H3
H4
H1H2H3
C
B
H4
H3H2H1
AED
H4
A
H1
H2
H3
Loading...