Page 1
Swivel Barstool Assembly
• Check to be sure that you have all parts and hardware
• Place all wooden pieces on a clean and smooth surface
like a carpet to avoid parts being scratched
• Do not tighten all screws/ bolts until completely
assembled
• Swivel plate top and bottom needs to be turned at 90-
degree angles prior to installation. If not pre-turned,
place swivel plates on your floor, use packaging carton
to protect the surface, step on swivel to twist using
your body weight
Parts
QTY
Top Seat Unit
(Pre-Assembled)
1
Base
(Pre-Assembled)
1
Swivel Plate
1
Seat Machine Bolts
4
Lock Washers
4
Flat Washers
8
#10 Philips Screws
4
4mm Allen Wrench
1
Bottom of base
Bottom of seat
(Fig 1)
(Fig 2)
(Fig 3)
Step 1. Place swivel on base with ‘TOP FRONT’ markings on swivel
facing upward. Attach swivel to base using four (4) #10 Philips screws
and four (4) flat washers. Tighten with a #10 Philips screwdriver (Not
Provided). (Fig 1)
Step 2. Place seat upside down on table or bench (lay a towel down to
protect from scratches) or on the edge of mattress. Flip base upside down
and place on top of Seat Unit bottom. Line up the four (4) slots in the
swivel top with the four (4) nut inserts that are mounted in the seat. (Fig 2)
*IMPORTANT: Make note of marking on top of swivel that reads
‘TOP FRONT’. This side of the swivel must be mounted toward the
front of the barstool seat in order to provide proper angle for sitting.
BEFORE YOU BEGIN
Step 3. Put one (1) Lock Washer and one (1) Flat Washer on each Seat
Machine Bolt. Attach the swivel to the seat bottom through the access
hole in the bottom of the base Unit with all four (4) bolts. (Fig 3)
Step 4. Screw all 4 bolts in half way with Allen wrench provided. Turning
base unit as needed to access the nuts that are inserted on the barstool
seat. Tighten all bolts fully when done. Assembly is complete!
Loading...