Page 1
PIECE QUANTITY
A 1X
B 2X
HW1 4X
HW2 12X
HW3
4X
HW4 4X
Step 1 Step 2
Step 3 Step 4
CARE AND MAINTENANCE
Spot clean using a mild water-free solvent. Only a professional cleaner should
undertake a complete overall cleaning.
The use of steam or water-based cleaners may cause excessive shrinking or staining.
NOTICE
* Please make sure that you have all parts indicated before you begin assembly of this
item
* This item should be assembled on a soft surface to prevent scratching the finish
during assembly
* This item may require periodic tightening
Parts List and Hardware List
DESCRIPTION
PICTURE
Headboard
Metal Leg
The hardware needed to connect the headboard to the bed
frame are 4 Philips bolts (HW4), 8 washers (HW2), and 4 nuts
(HW1)
Attach the legs of the headboard (B) to the bed frame or
mounting bracket by fixing them together through the 2
holes in the bed frame and the vertical slot in the leg using
4 small bolts (HW4), 8 washers (HW2) and 4 nuts (HW1)
Remove the legs (B) from the back of the headboard (A) by
unscrewing the 2 Philips bolts (HW3) and 2 washers (HW2).
The bolts and washers need to be re-used to attach the legs in
the correct position in Step 2.
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and
hardware contents list.
If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 10 minutes.
Attach the two legs (B) to the headboard (A) using 4
Philips bolts (HW3) and 4 washers (HW2).
The vertical slots at the lower part of the leg must be
facing the outside of the bed.
Philips bolt 6 x 1 x 25 mm
The hardware that is needed to connect the headboard to the bed frame is included.
Please note that our headboard legs are compatible to most standard bedframes. Our
headboards DO NOT include a mounting bracket*.
Example of Mounting
Bracket*
PREPARATION
Hex Nut 6 mm
Flat Washer 8,5 mm
Philips bolt 8 x 1 x 30 mm
HW1
HW2
HW2
HW4
B
B
B
A
B
HW3
HW2
HW1
HW2
HW2
HW4
Use the left slot to attach
the metal leg to the left
side of the metal frame
on the left side. Use the
right slot on the right
side.
A
B
Unscrew 2x HW3 bolts and 2x HW2 washers
B
ASSEMBLY INSTRUCTIONS APPLICABLE FOR ALL
THE DESIGN OF THE HEADBOARD IN THE
DRAWINGS MAY VARY FROM YOUR ACTUAL
HEADBOARD, BUT ASSEMBLY IS THE SAME ON ALL
MODELS AND SIZES.
Loading...