Page 1
ASSEMBLING&INSTALLA TIONINSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
ASSEMBLING
ASSEMBLING
ASSEMBLING
ASSEMBLING THE
1. Shut off the power at the circuit breaker box. Remove old fixture
and all hardware from Junction Box.
2. Carefully unpack your new fixture and lay out all the parts on a
clear area. Take care not to lose any small parts necessary for
installation.
3. Attach the tube (K) to the coupling of the fixture body(L) , attach
the tube (J) and (I) onto the pipe nipple of the tube (K), by turning
it clockwise until tight.
4. Attach the ring(Q),plate(P), canopy(G) onto the pipe nipple of the
tube (I) , and lock it securely with the washer and hex nuts(F).
5. End of pipe nipple screw into single bar (D), place lock washer (C)
over end of nipple protruding through single bar and lock it
securely with the hex nut (A). Take this single bar assembly to
junction box with junction box screws (E), tighten screws securely
with screwdriver . The side of the single bar marked "GND" must
face to out.
6. While holding the fixture lamp towards the ceiling , connect the
electrical wires as Shown in Fig.2, making sure that all wire nuts
are secured. You may have to wrap the connections with electrical
tape. If your outlet has a ground wire (green or bare copper),
connect the fixture ground wire to it. Otherwise connect fixture ’ s
ground wire directly to the Single bar with the green screw
provided. After wires are connected, tuck them carefully inside the
Junction Box.
THE
FIXTURE
THE
FIXTURE
THE FIXTURE
FIXTURE (
(
Fig.
(
Fig.
( Fig.
Fig. 1
1
)
1
)
1 )
)
Fig.1
7. Raise the fixture body on to the Junction box, aligning screws on
single bar with mounting hole in canopy and lock it securely with
the finial (H) . Attach the glass(M) to the socket holder and lock it
securely with the check ring(N).
8 . Install the light bulbs in accordance with the fixture ’ s specifications.
NOTE:
NOTE:
NOTE:
NOTE: DO
Your
Your
Your
Your installation
junction
junction
junction
junction box
DO
NOT
DO
DO NOT
installation
installation
installation is
box
box
box and
EXCEED
NOT
EXCEED
NOT EXCEED
EXCEED THE
and
and
and test
is
now
is
now
is now
now complete
test
the
test
the
test the
the fixture.
THE
SPECIFIED
THE
SPECIFIED
THE SPECIFIED
SPECIFIED WATTAGE.
complete
complete
complete Return
fixture.
fixture.
fixture.
Return
Return
Return power
WATTAGE.
WATTAGE.
WATTAGE.
power
power
power to
to
to
to the
the
the
the
Fig. 2
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green or
Bare Copper(Ground)
U
R
Listed
L
Loading...