Page 1
ASSEMBLING& INSTALLA TIONINSTRUCTIONS
ForCeilingMountFixtures
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
MOUNTING
MOUNTING
MOUNTING
MOUNTING THE
THE
FIXTURE
THE
FIXTURE
THE FIXTURE
FIXTURE (Fig.1)
(Fig.1)
(Fig.1)
(Fig.1)
1. Shut off the power at the circuit breaker box. Remove old
fixture and all hardware from Junction Box.
2. Carefully unpack your new fixture and lay out all the parts
on a clear area. Take care not to lose any small parts
necessary for installation.
3. Thread the two Mounting screw (A) about 1/4 ” into the
pre-drilled holes in the Mounting plate spaced the same
distance apart as the holes in the canopy (B).
4. Attach the Mounting plate to the Junction Box with the two
Junction Box Screws as shown. The side of the Mounting
plate marked " GND " must face out.
5. While holding the canopy assembly towards the ceiling,
connect the electrical wires as Shown in Fig.2, making
sure that all wire nuts are secured.
You
may have to wrap
the connections with electrical tape. If your outlet has a
ground wire (green or bare copper) , connect the fixture
ground wire to it . Otherwise connect fixture’s ground wire
directly to the Mounting plate with the green screw
provided. After wires are connected, tuck them carefully
inside the Junction Box.
6.
6.
6.
6. R aise the canopy assembly onto the junction box, aligning
screws on mounting plate with mounting holes in canopy
and lock it securely with the ball nut (C).
7.
7.
7.
7. Install the light bulbs in accordance with the fixture’s
NOTE:
specifications. NOTE:
SPECIFIED
SPECIFIED
SPECIFIED
SPECIFIED
NOTE:
NOTE: DO
WATTAGE.
WATTAGE.
WATTAGE.
WATTAGE.
DO
NOT
DO
NOT
DO NOT
NOT EXCEED
EXCEED
EXCEED
EXCEED THE
THE
THE
THE
8 . Thread the pipe nipple ( D ) into bottom center coupling of
the socket and lock it securely with the hex nut . Raise the
cover (F), glass shade ( E) and cover ( G ) to the bottom n ipple
of the canopy (B) , using the hex nut ( H ) by turning it
clockwise until tigh t and lock it with the finial (I).
Fig.1
Junction Box
Mounting plate
Box screw
Fixture wire
Supply wire
Wire nut
Supply
Ground wire
Mounting Screw ( A
Ground Screw
Fixture Ground wire
F
G
H
I
A
A
A )
B
C
D
E
Your
Your
Your
Your
junction
junction
junction
junction box
Fig. 2
FIXTURE
WIRES
Black or
Smooth
installation
installation
installation
installation is
box
and
box
and
box and
and test
HOUSE
WIRES
Black
(Hot)
is
now
is
now
is now
now complete.
test
the
test
the
test the
the fixture.
FIXTURE
WIRES
White or
Ribbed
complete.
complete.
complete. Return
fixture.
fixture.
fixture.
Return
Return
Return power
FIXTURE
WIRES
Bare
Copper
HOUSE
(Ground)
WIRES
White
(Neutral)
power
power
power to
to
to
to the
HOUSE
WIRES
Green or
Bare Copper(Ground)
the
the
the
MIN 90 ℃ SUPPLY CONDUCTORS
U
L
R
Listed
Loading...