ASSEMBLING & INSTALLATION INSTRUCTIONS
(
)
(
)
The drawing shown may not exactly match the product enclosed. However, the
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
MOUNTING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old fixture and
all hardware from Junction Box.
2. Carefully unpack your new fixture and lay out all the parts on a clear
area. Take care not to lose any small parts necessary for installation.
3. Thread the pipe screw part way into the center hole of the single bar
and secure with hex nut.
4. Attach the single bar to the junction box using two box screws as
shown. The side of the single bar marked “GND” must face
out . The junction box is not included.
5. While holding the lamp body towards the ceiling, connect the
electrical wires as Shown in Fig.2, making sure that all wire nuts
are secured. You may have to wrap the connections with electrical
tape. If your outlet has a ground wire (green or bare copper),
connect the fixture ground wire to it. Otherwise connect fixture’s
ground wire directly to the Mounting strap with the green screw
provided. After wires are connected, tuck them carefully inside the
Junction Box.
6. Raise lamp body onto the junction box, aligning pipe screw on
single bar with center hole in plate and lock it securely with the ball
nut.
7. Install the light bulbs(not included) in accordance with the fixture’s
specifications. NOTE: DO NOT EXCEED THE SPECIFIED
WATTAGE!
Your installation is now complete. Return power to the junction
box and test the fixture.
installation instructions do apply to this product.
FIG.1
FIG.3
FIXTURE
WIRES
BLACK
Junction Box
(Not included)
Lamp Body
FIXTURE
WIRES
WHITE
HOUSE
WIRES
Black
Hot
HOUSE
WIRES
Whi te
Neutral
FIXTURE
WIRES
GREEN
Thread
(Ground)
Green or
Copper(Ground)
Junction Box
(Not included)
Lamp Body
HOUSE
WIRES
Bare
Loading...