ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed.
However, the installation instructions do apply to this product.
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJ ON CTEUR.
ASSEMBLING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old fixture and all
2. Carefully unpack your new fixture and lay out all the parts on a clear area.
3. Mount the back plate(B) to the wall with the plastic anchors(A), the
4. Guide fixture wires through hole in center of back plate.
5. Follow wiring instructions carefully (see fig.2).
6. Place the lamp body(H) onto the back plate so that the back plate studs(C)
protrude through the cover plate holes and tighten it with the ball nut(I).
7. Raise the glass shade(G) to the lamp holder and using the check ring(F) by
turning it clockwise until tight.
8. Install the light bulbs in accordance with the fixture’s specifications.
NOTE: DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
CONNECTING THE WIRES (Fig.2)
1. Connect the electrical wires as follows. Connect the Black wire from the
fixture to the black house (hot) Wire. Connect the white wire from the fixture
to the white (neutral) house wire. Make sure all wire nuts are secured. You
may wrap the connections with electrical tape. If your outlet box has a
ground wires (green or bare copper) connect fixture’s ground wire to it.
Otherwise attach the bare copper fixture wire to the green ground screw on
the mounting plate.
2. Tuck the wire connections neatly into the wall junction box.
Your installation is now complete Return power to the junction box and
test the fixture.
hardware from Junction Box.
Take care not to lose any small parts necessary for installation.
wood screw(D) and the two box screw(E). The side of the back
plate marked “GND” must face out. The junction box is not included.
FIG.1
FIG.2
FIXTURE
WIRES
Black or
Smooth
Need assistance with parts or assembly? Please call customer service.
ALL RIGHTS RESERVED
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
Black(Hot)
HOUSE
WIRES
White
(Neutral)
Thank you for purchasing our product.
E
I
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green or Bare
Copper(Ground)
F
G
H
Loading...