Page 1
Page 2
Page 3
Safety Information
Important – Please read these instruction fully before installation.
Safety Precautions
For household and indoor use only.
Place the appliance on a flat, stable
surface with adequate ventilation and
away from other sources of heat.
Minimum distances around the
appliance for adequate ventilation is
5cm. Do not cover or restrict
ventilation openings.
Children should be supervised to
ensure they do not play with the
appliance, and the appliance and
cable should be kept completely out
of reach of young children.
Fully unwind the cable before
plugging in and ensure the cable is
positioned away from areas where it
is likely to get damaged or cause a
trip hazard.
Do not pull on cable to disconnect
form mains supply.
Do not operate the appliance if
damaged or after it malfunctions. In
the event the supply cord is
damaged, it must only be replaced by
a qualified service engineer, with a
suitably approved part.
This appliance is not designed for
use by children, or persons with
reduced physical, sensory or mental
capabilities, and should not be used
by such persons unless they can do
so safely. Where necessary, such
persons (or anyone with lack of
experience for knowledge) should
first be given supervision or
instruction concerning use of the
appliance by a person responsible
for their safety.
Keep appliance, cable and plug dry
and away from areas where it is
likely to get splashed. Avoid using
in hot, humid environments.
Do not place items with naked
flames or containers with liquids on
this appliance.
Switch off and unplug when not in
use and before cleaning or servicing
the appliance. Servicing of this
appliance must only be carried out
by a qualified electrician.
Always ensure the mains plug is
readily unpluggable – do not use
with ‘Lockable’ sockets or
permanently wire to mains.
1
Page 4
Safety Information
Important – Please read these instruction fully before installation.
Safety Precautions
To prevent possible
hearing damage, do not
listen at high volume
levels for long periods
.
This equipment is double
insulated and an earth
connection is not
required.
Dangerous voltage
constituting a risk of
electric shock is present
inside this equipment.
Dangerous voltage
constituting a risk of
electric shock is present
inside this equipment.
UK Mains plug information
This appliance must be connected to
a 230-240 volts 50Hz. AC supply by
means of a three pin socket, and
should be protected by a 3 Amp fuse.
If the mains plug is unsuitable for the
socket outlet in your home or is
removed for any other reason, then
the cut off plug should be disposed of
safely to prevent the hazard of electric
shock.
The wires in the mains lead on this
appliance are coloured in accordance
with the following code:
Blue – Neutral
Brown – Live
Under no circumstances should
Neutral or Live wires be connected to
the ‘E’ (Earth) terminal.
WARNING
RISK OF ELECTRIC SHOCK
DO NOT OPEN
The lightning flas h with arrowhead
symbol, within an equilateral
triangle, is intended to alert the
user to the presence of uninsulated
dangerous voltage" within the
product's enclosure that may be of
sufficient magnitude to constitute a
risk of electric shock to persons
TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK)
NO USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING TO
QUALIFIED SERVICE
PERSONNEL.
2
The exclamation point within
an equilateral triangle is
intended to alert the user to
the presence of important
operating and maintenance
(servicing) instructions in the
literature accompanying the
appliance.
Page 5
If you have damaged or missing parts,
Functions & Controls call the Customer Helpline: 0870 600 3030
Please familiarize yourself with the parts and accessories listed below
Accessories included
1 X PR-203 PORTABLE RADIO 1 X Mains cable 1 x Instruction manual
Overview of controls
1. Handle
2. FM antenna (telescopic)
3. Tuning control knob
4. Speaker
5. Waveband selector
6. Volume control – on/off knob
7. Headphone jack
8. AC socket
9. Battery compartment
3
Page 6
User Instructions
Battery installation
Note
To use the appliance with batteries ensure
that the AC power cord is NOT inserted
into the appliance and install the batteries
into the battery compartment (9). To
install the batteries –
1. Lift off the battery compartment
cover from the rear of the unit.
2. Insert 4 x Size “C” / UM-2 / LR14 (or
equivalent) 1.5V heavy-duty alkaline
batteries in accordance with the
diagram in the battery compartment.
Take care to observe the correct
polarity (+/ -).
3. Refit the battery compartment cover.
4. Do not expose the battery or the
installed battery to excessive heat (eg
fire, sunshine or position close to
Dispose of batteries responsibly at
local authority household waste
recycling facility.
DO NOT dispose of batteries in a
fire as the batteries may explode.
Only use ‘C’ 1.5V batteries in this
appliance.
Be sure to insert correctly taking
care to observe the correct
polarity (+ and -).
Use only batteries of the same or
equivalent type as recommended.
Do not recharge non-rechargeable
batteries.
Never mix old and new batteries
(replace all batteries at the same
time).
radiators etc.).
Never try to dismantle batteries.
Do not short circuit the supply
terminals.
Always remove exhausted or dead
batteries from the product, do not
dispose of in fire.
Remove batteries from the
product before extended storage.
AC Operation
This unit is supplied with a mains
cable. Fit the AC power cord into the
AC socket (8) of the appliance and plug
into the household socket.
4
Page 7
User Instructions
Radio operation
Using Headphones (not included)
1. Turn the volume control – on/off
knob (6) upward to switch the radio
on.
2. Set the waveband selector (5) to the
required waveband.
3. Turn the tuning control knob (3) to
select the frequency and station of
choice. The radio frequency scale
will show the waveband selected.
4. Adjust the volume to the desired
level by rotating the volume control
knob (6).
5. To turn off the radio, turn the
volume control – on/off knob (6)
downward until a “click” sound is
heard.
A headphone jack has been provided
so that the set can be used without
disturbing others. Plug in the 3.5mm
headphones at the point marked ‘ ’.
Turn the listening volume to the
lowest setting before adjusting the
volume up to your chosen level.
Excessive sound pressure from
earphones and headphones can cause
hearing loss. The speaker will not
operate when headphones are fitted.
Note :
The built-in AM and the external FM
antennas are directional. If tuning into a
FM station extend or move the antenna (2)
for a better reception. If tuning into a AM
station rotate the whole unit after tuning
to obtain the best reception.
5
Page 8
Care & Maintenance
Wipe external surfaces with a soft cloth. If the casing is very dirty, unplug from the
mains supply and use a damp cloth soaked in a weak solution of washing up liquid
and water. Allow to dry thoroughly before reusing.
Troubleshooting Guide
In the unlikely event of difficulties with your appliance please follow the trouble
shooting guide below. If the problem persists, contact the retailer if the machine
is still under guarantee. Customer Helpline: 0870 600 3030
Problem Reason(s) Solution
Unit not powering on Not connected to a
wall socket.
No sound The Audio cable is not
(or not securely)
connected.
The volume is turned
down.
Radio reception weak AM Signal
FM Signal
Connect the PR-203 to
power
Make sure all
connections are firm
and secure
Turn the volume up.
AM signals – rotate the
unit to improve
reception.
FM signal – extend or
adjust the position of
FM antenna.
6
Page 9
T
Technical Specifications
General
Power AC 230 – 240V~ 50Hz
DC 4 x 1.5V Battery size “C”/UM-2/LR14
(Batteries not included)
Power consumption 5W
Dimensions Approx. 215mm(L) x 55mm(D) x 125mm (H)
uner
AM 530 – 1600 kHz
FM 88 – 108 MHz
Audio
Audio output 0.36W RMS
Speaker 8 ohms
We apologise for any inconvenience caused by any minor inconsistencies in these instructions,
which may occur as a result of product improvements and development.
This appliance complies with the following EC directives : 2006/95/EC Low voltage
directive / 2004/108/EC EMC directive
Disposal Information
The symbol on the product or its packaging indicates that this product may not be
treated as household waste. Instead it should be handed over to the applicable
collection point for the recycle of electrical and electronic equipment. By ensuring this
product is disposed of correctly, you will help prevent potential negative consequences
for the environment and human health, which could otherwise be caused by
inappropriate waste handling of this product. For more detailed information about
recycling this product, please contact your local council office, your household waste
disposal service or the shop where the product was purchased.
7
Page 10
8
Loading...