AKG Acoustics HSC 200 SR User Manual

HSC 200 SR

Broadcast Headset

Description

The HSC 200 SR is a combination of semi-open stereo
headphones and an adjustable electret microphone. The
microphone element rests in a shock mount that suppresses both
cable noise and acoustic headphone leakage.

The microphone operates on phantom powering over the range
from 9 to 52 volts dc. Microphone sensitivity is 7 mV/Pa at 1 kHz.
The microphone connector is a 3-pin XLR type and the headphone
connector is a 0.25 in. (6.3 mm) ring-tip-sleeve stereo jack.

Specifications

Microphone

Transducer Principle: Condenser prepolarized

Frequency Range: 20–20,000 Hz

Polar Pattern: Cardioid

Sensitivity at 1,000 Hz: 7 mV/Pa ^= -43 dBV

Equivalent Noise Level: < 22 dB-A

S/N Ratio (A-weighted): > 69 dB

Electr. Impedance: < 200 ohms

Load Impedance: > 2,000 ohms

Power Requirement: 9 to 52 volts phantom power

Connector: 3-pin XLR type

Headphones

Transducer Principle: Dynamic

Type: Semi-open, supra aural

Frequency Range: 20–20,000 Hz

Rated Impedance: 100 ohms/system

Finish: Non-reflective black

Connector: Gold plated 0.25 in. (6.3 mm)

stereo jack

Net/Shipping Weight: 8.8 oz./1 lb. (250 g/450 g)

Included Accessories: Foam windscreen,

Phantom power adapter

Optional Accessory: B 18 E Battery Power Supply

Features

• Semi-open headphones

• Shock mounted microphone

• Flexible gooseneck

• Phantom power adapter

• Bass roll-off

• Rugged and lightweight design

Microphones · Headphones · Wireless Microphones · Wireless Headphones · Headsets · Electroacoustical Components

Limited Warranty

Valid only in the United States. AKG Acoustics warrants AKG products against defects in material
or workmanship for a period of two years from the date of original purchase for use, and agrees to
repair or, at our option, replace any defective unit without charge for either parts or labor. Important:
This warranty does not cover damage resulting from accident, misuse or abuse, lack of reasonable
care, the affixing of any attachment not provided with the product, loss of parts or connecting the
product to any but the specified receptacles. This warranty is void unless service or repairs are
performed by an authorized service center. No responsibility is assumed for any special, incidental

or consequential damages. However, the limitation of any right or remedy shall not be effective
where such is prohibited or restricted by law. Simply take or ship your AKG product prepaid to our
service department. Be sure to include your sales slip as proof of purchase date. (We will not repair
transit damage under the no-charge terms of this warranty.) Note: No other warranty, written or oral
is authorized by AKG Acoustics, Inc. This warranty gives you specific legal rights, and you may also
have other rights which vary from state to state. Some states do not allow the exclusion or
limitation of incidental or consequential damages or limitation on how long an implied warranty
lasts, so the above exclusions and limitation may not apply to you.

Specifications subject to change without notice.

AKG Acoustics GmbH

Lemböckgasse 21–25, P.O.B. 158, A-1230
Vienna/AUSTRIA
Tel: [phone]*, Fax: [phone]
Internet: http://www.akg.com

AKG Acoustics; A Division of Harman Pro Germany
Bodenseestraße 228, D-81243 München/GERMANY
Tel: [phone], Fax: [phone]

Arbiter Pro Audio

Wilberforce Road, London NW9 6AX/ENGLAND
Tel: [phone], Fax: [phone]

AKG ACOUSTICS, U.S.

914 Airpark Center Drive
Nashville, TN 37217, U.S.A.
Tel: [phone], Fax: [phone]

Studer Japan Ltd.

2-43-7, Uehara, Shibuya-ku, Tokyo 151-0064/JAPAN
Tel: [phone], Fax: [phone]

Erikson Pro Audio

620 McCaffrey, St-Laurent, Quebec, H4T 1N1, CANADA
Tel: [phone], Fax: [phone]
Internet: www.jam-ind.com/eriksonpro

AKG is constantly improving and modifying its products, therefore, specifications are subject to change without notice.

DS-HSC 200 SR

The microphone shall be an electret element with a sensitivity no
less than 7 mV/Pa (-43 dBV) capable of phantom powering over
the range from 9 to 52 volts dc. The microphone’s frequency
response shall be uniform from 50 Hz to 20 kHz, ±5 dB. The

dynamic range of the microphone shall be no less than 69 dB. The
microphone shall include a two-layer windscreen for minimizing
airstream induced noise. The microphone-headset combination
shall be the AKG Acoustics Model HSC 200 SR.

Graphical Data

Architects and Engineers Specifications

ECHT

LEDER

RECYCLING-

1.9 (50 mm)

4.2” (105 mm)

105

50

ECHT

RECYCLING-

LEDER