Akerstroms Bjorbo S506 Installation manual

INSTALLATION MANUAL SESAM 506 92 7123-000 Ver. A0 Page 1(2)

Incoming

SESAM 506- Door opening system

TRANSMITTER

The transmitter operates on a 9V alkaline battery. Pushbutton 1, 4 = OPEN, button 2, 5 = CLOSE, button 3, 6 = STOP

RECEIVER

The permanent installation of the building must submit fuses, which
protects the equipment and wiring from over-current and short-circuit. The
power supply of the equipment and all relay-contacts must be fused.

All that fuses are used as separation devices. They must be easily accessible,
must submit a contact-gap of at least 3.0 mm and has to be placed in the line
pole (L).

After the installation of the equipment, the installed cables must be
bound together (e.g. by using a cable binder) very close to the terminal
blocks.

If the receiver is mounting unprotected for rain it must be mounted
horizontally.

Figur 1. Receiver 3 functions

CODING

The receiver and the transmitter have to be coded by the electrician. The transmitter and receiver
are provided with 10-pole switches SW1 with 3 possible positions (+, 0, -).

Switch 1-3

The code is divided into two parts, area code and door code.
The area code (switch 1-3) has to be identical for all the transmitters and the receivers, which are to
be working together.

Switch 4-10

Door codes are coded as example below.

Transmitter

Corresponding port number in the receiver

gives Upper line Lower line

voltage 115 VAC

In areas with more than 2 ports you have to code after the table. Switch 1-6 are coded identically
in transmitter and receiver. The upper button line on the transmitter correspond to the lower port­number in the table. The lower button line on the transmitter correspond to the upper portnumber in
the table.

FCC Identifier OG4S506

INSTALLATION MANUAL SESAM 506 92 7123-000 Ver. A0 Page 2(2)

Coding example receiver

Coding port 16. Code as
illustration (9+6+1=16)

The receivers code for port 16. The upper line in transmitter 506.

Coding port 17. Code as
illustration. (9+6+2=17).

PLUG IN

Coding see above.

Plug in receiver

Incoming voltage 12-24
VAC or DC is connected
to pin 5 and 6 (independent
polarized). What concerns
the relay outputs see figure

2.

For 1-relays receiver

With switch SW2 You can
choose which push button
on the transmitter which
have to set function out on
the receiver sees below.

The receivers code for port 17. The lower line in transmitter 506.

Figur 2. Receiver with 1 respective 3
functions

PLUG IN TRANSMITTER 506
SW2:1 ON other OFF Button 1, 4
SW2:2 ON other OFF Button 2, 5
SW2:3 ON other OFF Button 3, 6

Caution:

Any changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.

FCC Identifier OG4S506