AirSep MN027-1 User Manual

AirSep Software & Driver Installation for

Focus / FreeStyle 5 Data Interface

1.) Insert the installation CD.

2.) Click setup.exe. and install the software.

NOTE: If the installation does not automatically begin, open My Computer. Within
the My Computer window, click on the CD or DVD drive that contains the
installation files and run setup.exe.

3.) When the installation is complete, you will see the following window:

DO NOT CLOSE THIS WINDOW OR REMOVE THE CD UNTIL THE

CABLE INTERFACE DRIVERS ARE INSTALLED

4.) With the above window open, plug the Focus / FreeStyle 5 Interface
Cable into an open USB port.

5.) The computer will prompt you that it has Found New Hardware.

6.) You will then be prompted that the New Hardware is Installed and
Ready to Use.

7.) Your software and cable drivers are now installed. You may now close

the Installation Window and remove the CD.

8.) The Installation Software created the following icon on your desktop
to access the Interface program.

MN027-1 Rev -

PDF created with pdfFactory Pro trial version www.pdffactory.com