Page 1
AUTOMOTIVE ACCESSORY
MANUFACTURE & DISTRIBUTION
AIRPLEX INDUSTRIES LTD
21 Saleyards Road, Otahuhu, Auckland 1062, New Zealand
PO Box 11286, Ellerslie, Auckland 1542 New Zealand
PH +64 (9) 276-9826 Fax +64 (9) 276-9836
[email protected] www.airplex.co.nz
FITTING INSTRUCTIONS FIT1264_1
PLEASE READ INSTRUCTIONS COMPLETELY BEFORE INSTALLATION
BONNET GUARD
FORD TRANSIT CUSTOM 2024+
BG649D &
BG672D
MADE IN NEW ZEALAND
1. Clean and open bonnet.
2. Trial fit the Bonnet Guard and note the 1 pre-drilled holes in the Bonnet Guard that
correspond with the slot holes in the underside of bonnet.
3. Fit plastic grommet to the slot hole
4. Fit Bonnet Guard in position (between the rubber weather-strip and the car
bonnet) and fasten securely with supplied screw.
Note sequence as per diagram as below.
5. Apply the anti-abrasive tape on edge of bonnet where plastic fastening clip
secures the Bonnet Guard near the fenders. Use the supplied alcohol preppads to cleanse the area first.
6. Snap the supplied plastic “W” clip into hole position on Bonnet Guard as shown,
over the anti-abrasive tape.
Wash acrylic with a mild soap and lukewarm water solution, using a clean, soft cloth or sponge.
Loading...