Page 1
AUTOMOTIVE ACCESSORY
MANUFACTURE & DISTRIBUTION
AIRPLEX INDUSTRIES LTD
21 Saleyards Road, Otahuhu, Auckland 1062, New Zealand
PO Box 11286, Ellerslie, Auckland 1542 New Zealand
PH +64 (9) 276-9826 Fax +64 (9) 276-9836
[email protected] www.airplex.co.nz
FITTING INSTRUCTIONS FIT1078
PLEASE READ INSTRUCTIONS COMPLETELY BEFORE INSTALLATION
ISUZU DMAX 2020+
BG611
MADE IN NEW ZEALAND
1. Clean and open bonnet.
2. Fit Bonnet Guard in position & fasten
securely with 2 supplied plastic “push pin”
and screw.
3. Fit the plastic “W” clips to the 4 holes at the outer
edge of the Bonnet Guard. Apply the supplied
rectangular pieces of anti-abrasive tape on edge of
bonnet where plastic fastening “W” clips secure the
Bonnet Guard.
Use the supplied alcohol prep-pads to cleanse the
area first.
CLOSE THE BONNET BY DROPPING FROM 6" HEIGHT.
ASSIST CLOSURE ONLY BY PRESSING ON THE BONNET.
NEVER PRESS ON THE BONNET PROTECTOR.
plastic “W” clip
anti-abrasive tape
(applied to clean hood)
Hood Protector / Bonnet Guard
Loading...