airmaxeco airmax Maintenance Manual
Maintenance & Operation
of the Control Panel Timer
RUN TIME USING THE MANUAL BYPASS
Press the MANUAL button until the line is above “ON”. This mode will bypass
all programmed settings.
RUN TIME USING A PROGRAM
Setting the Clock
Step 1: Press the RESET button to clear all history
from memory.
Step 2: Press and hold the CLOCK button.
Step 3: Continue to hold the CLOCK button
while pressing the DAY, HOUR or
MIN button to set the day and time.
Step 4: Release the CLOCK button.
CREATING A PROGRAM
The Airmax NEMA 3R Powder Coated Control Panel allows
up to 8 ON/OFF run times.
Select the days for each run time to occur based on the 15 preset
schedule of days listed below.
Note: Ponds will receive the most benet from continual water
movement. We recommend running fountains at least 8-10 hours daily,
to maximize benets, unless a secondary aeration system is in operation.
Step 1: Press the TIMER button once to display ”1on --:--“
Step 2: Press the DAY button to scroll through the preset schedule
options.
Step 3: When the desired schedule is displayed press the HOUR or MIN
buttons to select the ON time.
Step 4: Press the TIMER button once to switch display to “1o --:--“
Step 5: Press the DAY button to scroll to the program selected in step 2.
Step 6: Press the HOUR or MIN button to select the OFF time.
Step 7: Repeat steps 1-6 for each additional program desired, up to 8
programs.
Step 8: When all programs have been created press the CLOCK button
to execute the programs.
Step 9: Press the MANUAL button until the line is above AUTO.
EDITING A PROGRAM
Review a Program – To review the list of current programs press the
TIMER button repeatedly to scroll through the programs. When nished
press the CLOCK button to return to the time of day.
Change an On/O Time – To adjust an on o time press the TIMER
button to scroll to the program you will to change. Press the DAY, HOUR
or MIN buttons to adjust the time. When nished press the CLOCK
button to return to the time of day.
Reset Button
EDITING A PROGRAM CONT.
Add a Program – If there are not already 8 programs
running you may elect to add an additional program
by following. See CREATING A PROGRAM
Remove a Program – In the event that a program
needs to be removed you will need to RESET the
timer and program only the desired schedules.
a. MO TU WE TH FR SA SU
b. MO
c. TU
d. WE
e. TH
f. FR
g. SA
h. SU
i. MO TU WE TH FR
j. SA SU
k. MO TU WE TH FR SA
l. MO TU WE
m. TH FR SA
n. MO WE FR
o. TU TH SA
MAINTENANCE:
REPLACING THE BATTERY
Note: Timer settings will be retained for approximately 1
minute once the battery is removed. Each timer uses (1)
CR2032 Lithium Battery.
Step 1: On the back of the timer use a small athead
screwdriver or similar to pull the battery
compartment from the timer.
Step 2: Install a new battery and reinstall the
battery compartment.
Gently Pull Here
airmaxeco.com | 866-424-7629 | P.O.Box 38 | Romeo, MI 48065
Loading...