Airlink101 AICN500 User Manual

Quick Installation Guide

SkyIPCam500 Night Vision Network Camera

Model # AICN500

Ver. 1A

Package Contents:

• Night Vision Network Camera

• Camera Stand

• Power Adapter

• Ethernet Cable (Cat.5)

• Utility CD

• Quick Installation Guide

Section 1

This Quick Installation Guide only provides basic instructions. For detailed

information on using this product, please refer to the User’s Manual on the

supplied CD.

Getting Started

Step 1 Connect one end of the Ethernet cable to the IP Camera and connect

the other end to one of the LAN ports on your router or switch.

Step 2 Power on the IP Camera by connecting one end of supplied power

adapter to the power jack of the Camera and connecting the other end to the
electrical outlet.

Step 3 Verify that the yellow light (Power) is solid and the green light (Link) is

blinking.

Section 2

Installing the SkyIPCam Utility

Step 1 Insert the provided CD and wait for the auto-run screen to appear.
Step 2 Click on Install SkyIPCam Utility.

Note

: If the auto-run screen does not appear automatically, go to Start, Run,

type:
D:\ Utility\Setup.exe (where D is the letter of your CD drive) and click OK.

Step 3 Keep clicking Next on the following screens.

Step 4 Click Close to complete the installation.

Section 3

Using the SkyIPCam Utility

Step 1 Go to Start > (All) Programs > AirLink101 > AirLink101 SkyIPCam

Utiliy

Step 2 Select the IP Camera you want to configure from the list and click on the

Change IP button.

Note

: If the Camera’s IP address does not show up in the window, make sure
the camera is properly connected to the same network as your computer is,
and then click on the Search button.