Airlink101 AICAP650W User Manual

SkyIPCam650W

Model # AICAP650W

Quick Installation Guide

Ver. 1.0

Section 1

Getting Started

This Quick Installation Guide only provides the basic instructions. For more
detailed information, please refer to the User’s Manual in the supplied CD.

Caution: The IP Camera is designed for indoor use only. Direct exposure to sunlight

may cause permanent damage to the CMOS sensor. When operating in extremely
bright environment, an iris lens or sun visor is recommended to protect the IP Camera.

System Requirement: Before you begin, please review the following system requirement.

• OS: Windows® 98SE/ME/2000/XP.

• CPU: 650MHz or above (2.4 GHz recommended when monitoring multiple cameras simultaneously)

• Memory Size: 256MB

• Resolution: 1024x768 or above

• Web Browser: Internet Explorer 5.0 or above

Step 1 Align the camera stand with the bottom part of the camera. Then, secure the camera st and with

the screw.

Step 2 Connect one end of a network cable to the IP Camera and connect the other end to one of the

LAN ports of the wireless router.

Step 3 Power on the IP Camera by connecting one end of the supplied power adapter to the power jack

of the Camera and connecting the other end to an electrical outlet.

Step 4 V erify that the LED lights on the Camera are lit. If not, verify that all the connections are secure

and try again.

Section 2

Installing the Setup Wizard

Step 1 Insert the provided CD and wait for the autorun screen to appear .
Step 2 Click on Install Setup Wizard.

Note: If the autorun screen does not appear automatically, go to Start > Run > and type
D:\Setup\Setup.exe (where D is the letter of your CD drive) and click OK.

Step 3 Click Next.

Step 4 Click Yes to accept the License Agreement.

Step 5 Click Next to accept the default Destination Folder .

Step 6 Click Finish to complete the installation.

Section 3

Using the Setup Wizard

Step 1 Go to St art > (All) Programs > AirLink101 IP Camera Setup Wizard > AirLink101 IP Camera

Setup Wizard.

Step 2 Select the IP Camera you want to configure from the list and click on the Wizard button.