Airlink101 AGSW1600 User Manual

Quick Installation Guide

16-Port 10/100/1000Mbps

Green Switch

Model# AGSW1600

Ver. 1A

Trademarks

Copyright © 2011 Airlink101®
Airlink101® is a registered trademark. All other trademarks
belong to their respective proprietors.

Copyright Statement

No part of this publication may be reproduced in any form or
by any means or used to make any derivative such as
translation, transformation, or adaptation without permission
from Phoebe Micro, Inc.

Preface

FCC Warning

This device has been tested and found to comply with limits
for Class A digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment
is operated in a commercial environment. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the user’s
manual, may cause interference in which case the user will
be required to correct the interference at his own expense.

CE Mark Warning

This is a Class A product. In a domestic environment, this
product may cause radio interference in which case the
user may be required to take adequate measures.

1

Introduction

Congratulations on your purchase of the 16-Port
10/100/1000Mbps Green Switch! It is an easy-installed
network switch which helps you to extend your network
structure quickly and reliably. The 16-Port 10/100/1000Mbps
Green Switch is designed for energy saving, easy installation
and high performance in an environment where network
traffic and the number of users increase continuously. You
can add other Ethernet devices like computers, IP cameras,
and Network Attached Storage (NAS) onto your network
quickly and easily. The Green EEE (Energy Efficient Ethernet)
technology of AGSW1600 automatically reduces the power
usage when a connected port is detected inactive (idle or
cable-unplugged) and intelligently allocates less power for a
port that connects with an Ethernet cable shorter than 20m
(66 ft)*.

Before you begin the installation, please check the items of
your package:

Package Contents:

• 16-Port 10/100/1000Mbps Green Switch

• Power Cord

• Quick Installation Guide

• Brackets and Screws

2

Section 1

Hardware Description

1.1 Hardware Interface

• 16-Port 10/100/1000Mbps auto-negotiation RJ45 Ports

• All ports support auto MDI/MDIX, no need to use

cross-over cables

1.2 Panel

1.2.1 Front Panel

The front panel of the Switch consists of LED indicators, and
16 10/100/1000Mbps ports. The figure below shows the front
panel of the Switch.

Figure 1-1 Front Panel view of the Switch

• 10/100/1000Mbps Ports (Port 1~16): These ports support
10/100/1000Mbps, and can operate in Half/Full Duplex
transfer modes. These ports also support automatic
MDI/MDI-X crossover detection, giving true “plug and
play” capability.

• LED Indicators: Comprehensive LED indicators display
the status of the Switch and the network (see Section

1.2.3).

3