Airlink Raven-E iDEN User Manual

Raven-E iDEN

Quick Start

Copyright © 1993-2006 AirLink Communications, Inc. All rights reserved.

Version 2.40 - September 2006

Raven-E iDEN for TELUS - Quick Start,
version 2.40

The SIM (Subscriber Identity Module) card in the Raven-E is a smartcard securely storing the key
identifying a mobile subscriber. Generally, you will only need to install the SIM once in the life of
the modem and it may be pre-installed by AirLink.

For additional modem configuration options, please refer to the Raven-E iDEN
Users Guide for TELUS.

Note: If the SIM card was pre-installed by AirLink, there is nothing more you

need to do. Skip to the Hardware section and/or to the DUN instructions, if you
need Dial-Up Networking.

Installing the SIM

To install the SIM, you will only need a sm all phillips head screw driver.

1.

Opening the Case

a. Unplug the Raven-E’s power and all cables.
b. Using a small phillips head screw driver, remove the screws on the back of the Raven-E.
c. Slide the casing off of the Raven-E and set it aside.

FIGURE 1. Raven-E back

2.

September 2006 1

Ejecting the SIM tray

Raven-E iDEN for TELUS - Quick Start, version 2.40

a. Using the tip of a PDA stylus, an unbent paperclip, or other slim blunt item press the yellow
button of the SIM tray. On the Raven-E, the button is between two boards.

FIGURE 2. Tray button: Raven-E

b. Slide the tray out of the slot.

FIGURE 3. Empty SIM Tray

3.

Inserting the SIM

a. Place the SIM into the tray and gently press to click it into place.

FIGURE 4. SIM Tray with a SIM

The SIM may be a different color than this
example.

b. Slide the tray back into the modem and gently press to click it into place.

FIGURE 5. Inserting the SIM: Raven-E

September 2006 2