User manual
AK3IN1-40BK
TECHNICAL SPECIFICATIONS
AK3IN1-40BK
Model:
Power Supply: 220-240V~ 50Hz
Rated Power: 55W
Class II:
Conforms to all relevant European Directives.
IMPORTANT INSTRUCTIONS
Read and save these important safety instructions
before using this fan, when using electrical appliances,
basic safety precautions should always be followed
including the following:
WARNING - To reduce the risk of fire or electrical shock,
do not use this product with any solid state speed control
device. To reduce the risk of fire or electric shock and
injury to persons, do not use in a window.
Use this fan only as described in this manual. Other
uses not recommended may cause fire or electric
shock.
This product is intended for HOUSEHOLD USE ONLY
and not for commercial, industrial or outside use.
To protect against electrical shock, do not place fan in
window, immerse unit, plug or cord in water, or spray
with liquids.
Unplug the fan from the outlet when not in use, when
moving fan from one location to another and before
cleaning.
Do not operate the fan in the presence of explosive
and/or flammable fumes.
Do not place the fan or any parts near an open flame,
cooking or other heating appliance.
Avoid contact with moving fan parts.
To disconnect, grip the plug and pull it from the wall
outlet. Never yank the cord.
The use of attachments is not recommended and
may cause hazards.
Always use on a dry, level surface.
Do not operate if the fan housing is removed or
damaged.
Do not operate any fan with a damaged cord or plug.
Discard fan or return to an authorized service facility
for examination and/or repair.
Do not run cord under carpeting. Do not cover cord
with throw rugs, runners, or similar coverings. Do not
route cord under furniture or appliances. Arrange cord
away from traffic area and where it will not be tripped
over.
The appliance is not to be used by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
Children being supervised not to play with the
appliance
This appliance can be used by children aged from 8
years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe
way and understand the hazards involved.
Children shall not play with the appliance.
Cleaning and user maintenance shall not be made
by children without supervision.
ASSEMBLY
1. Carefully remove the Fan
from the carton. Place Base
flat on floor.
2. Stand Fan Option - With a
twisting motion, insert the end
of the Pipe (7) into hole in
Base.
Floor Fan Option - With a
twisting motion, insert the end
of the Pipe (9) into hole in
Base.
3. Place the Head Assembly
onto the end of Pipe and
continue turning until it is
tightened on the pole.
HOW TO OPERATE
1. Set the fan on a level and dry surface.
2. Plug the power cord into the socket. Making sure
the speed control is at OFF position.
Using the Remote Control - Open the cover at the
bottom of the remote control and insert the batteries.
OFF: Allows to switch off the fan.
ON/SPEED: Allows to switch on
and set the speed.
TIMER: The fan has an automatic timer to turn the
unit OFF of up to 7 hours.
Adjust the fan to your desired angle by moving the
head up or down.
5. After turning the Fan off, unplug the unit from the
electrical outlet.
CLEANING
Be sure your fan is in the OFF position.
Unplug the fan before cleaning.
Use only a soft, damp cloth to gently wipe
the fan.
DO NOT immerse the fan in water and
never allow water to enter the Motor
Housing.
DO NOT use gasoline, paint thinner or
other chemicals to clean the fan.
NEVER attempt to take apart the Fan.
PLEASE READ AND SAVE THESE IMPORTANT INSTRUCTIONS
This fan is for residential use only. It is not intended to be used in commercial or industrial settings.
16-inch {40cm}
Power Stand & Floor Fan
with remote control
STORAGE INSTRUCTIONS
The product must be packaged in its original box for
storage. Place the fan in a storage room with low
humidity.
TROUBLE SHOOTING TIPS
If your Fan fails to operate, see below for a probable
cause and solution.
- Be sure the power cord is plugged into a working
electrical outlet.
If you have a problem that can not be resolved by the
step listed above, please return the fan to the place of the
original purchase or see your warranty. Do not attempt to
open the motor housing yourself; doing so may void your
warranty and cause damage to the fan or personal injury.
DESCRIPTION OF PARTS
1. Front Grille
2. Blade
3. Control Panel
4. Carry Handle
5. Tilt Axis
6. Rear Grille
7. Pole
8. Base
9. Remote Control Unit